Search Results
Bulk single crystals and physical properties of β-(AlxGa1-x)2O3(x = 0-0.35) grown by the Czochralski method
2023, Galazka, Zbigniew, Fiedler, Andreas, Popp, Andreas, Ganschow, Steffen, Kwasniewski, Albert, Seyidov, Palvan, Pietsch, Mike, Dittmar, Andrea, Anooz, Saud Bin, Irmscher, Klaus, Suendermann, Manuela, Klimm, Detlef, Chou, Ta-Shun, Rehm, Jana, Schroeder, Thomas, Bickermann, Matthias
We have systematically studied the growth, by the Czochralski method, and basic physical properties of a 2 cm and 2 in. diameter bulk β-(AlxGa1-x)2O3 single crystal with [Al] = 0-35 mol. % in the melt in 5 mol. % steps. The segregation coefficient of Al in the Ga2O3 melt of 1.1-1.2 results in a higher Al content in the crystals than in the melt. The crystals were also co-doped with Si or Mg. [Al] = 30 mol. % in the melt (33-36 mol. % in the crystals) seems to be a limit for obtaining bulk single crystals of high structural quality suitable for homoepitaxy. The crystals were either semiconducting (no intentional co-dopants with [Al] = 0-30 mol. % and Si-doped with [Al] = 15-20 mol. %), degenerately semiconducting (Si-doped with [Al] ≤ 15 mol. %), or semi-insulating ([Al] ≥ 25 mol. % and/or Mg-doped). The full width at half maximum of the rocking curve was 30-50 arcsec. The crystals showed a linear but anisotropic decrease in all lattice constants and a linear increase in the optical bandgap (5.6 eV for [Al] = 30 mol. %). The room temperature electron mobility at similar free electron concentrations gradually decreases with [Al], presumably due to enhanced scattering at phonons as the result of a larger lattice distortion. In Si co-doped crystals, the scattering is enhanced by ionized impurities. Measured electron mobilities and bandgaps enabled to estimate the Baliga figure of merit for electronic devices.
Perspectives on MOVPE-grown (100) β-Ga2O3thin films and its Al-alloy for power electronics application
2022, Rehm, Jana, Chou, Ta-Shun, Bin Anooz, Saud, Seyidov, Palvan, Fiedler, Andreas, Galazka, Zbigniew, Popp, Andreas
Beta gallium oxide (β-Ga2O3) is a promising ultra-wide bandgap semiconductor with attractive physical properties for next-generation high-power devices, radio frequency electronics, and solar-blind ultraviolet radiation detectors. Here, we present an overview and perspective on the development of MOVPE-grown (100) β-Ga2O3 thin films and its role in supplementing high-power electronics. We review the development path of the growth process on (100) β-Ga2O3 thin films with a discussion regarding the solved and remaining challenges. The structural defect formation mechanism, substrate treatment strategies, and different growth windows are analyzed to optimize the grown film to fulfill the requirements for device fabrication. Toward industrial applications, MOVPE-grown β-Ga2O3 thin films are evaluated in two aspects: thick layers with smooth surface roughness and the electrical properties in terms of high carrier mobility and low doping concentration. Based on the reviewed results, we propose strategies in substrate preparation treatments and supportive tools such as the machine learning approaches for future growth process optimization and envision the rising interest of the β-Ga2O3-related alloy, β-(AlxGa1-x)2O3.
Effect of post-metallization anneal on (100) Ga2O3/Ti–Au ohmic contact performance and interfacial degradation
2022, Lee, Ming-Hsun, Chou, Ta-Shun, Bin Anooz, Saud, Galazka, Zbigniew, Popp, Andreas, Peterson, Rebecca L.
Here, we investigate the effect of post-metallization anneal temperature on Ti/Au ohmic contact performance for (100)-oriented Ga2O3. A low contact resistance of ∼2.49 × 10−5 Ω·cm2 is achieved at an optimal anneal temperature of ∼420 °C for (100) Ga2O3. This is lower than the widely-used temperature of 470 °C for (010)-oriented Ga2O3. However, drastic degradation of the (100)-oriented contact resistance to ∼1.36 × 10−3 Ω·cm2 is observed when the anneal temperature was increased to 520 °C. Microscopy at the degraded ohmic contact revealed that the reacted Ti–TiOx interfacial layer has greatly expanded to 25–30 nm thickness and GaAu2 inclusions have formed between (310)-Ga2O3 planes and the Ti–TiOx layer. This degraded interface, which corresponds to the deterioration of ohmic contact properties, likely results from excess in-diffusion of Au and out-diffusion of Ga, concurrent with the expansion of the Ti–TiOx layer. These results demonstrate the critical influence of Ga2O3 anisotropy on the optimal post-metallization anneal temperature. Moreover, the observed Ti/Au contact degradation occurs for relatively moderate anneal conditions (520 °C for 1 min in N2), pointing to the urgent necessity of developing alternative metallization schemes for gallium oxide, including the use of Au-free electrodes
High-mobility 4 μm MOVPE-grown (100) β-Ga2O3 film by parasitic particles suppression
2023, Chou, Ta-Shun, Seyidov, Palvan, Bin Anooz, Saud, Grüneberg, Raimund, Rehm, Jana, Tran, Thi Thuy Vi, Fiedler, Andreas, Tetzner, Kornelius, Galazka, Zbigniew, Albrecht, Martin, Popp, Andreas
In this work, we comprehensively investigate the development of unwanted parasitic particles in the MOVPE chamber while growing μm level films. The density of the parasitic particles is found to be pronounced at film thicknesses starting from >1.5 to 2 μm. These particles seem to induce structural defects such as twin lamellae, thereby harming the electrical properties of the grown film. The origin of the parasitic particle is attributed to the parasitic reactions within the chamber triggered by the promoted gas-phase reactions during the growth process, which can be largely reduced by increasing the total gas flow and decreasing the showerhead distance to the susceptor. A film thickness of up to 4 μm has been achieved after minimizing the density of parasitic particles. Thereby, RT Hall measurements reveal carrier mobilities of 160 cm2V−1s−1 at carrier concentrations of 5.7 × 1016cm−3
Suppression of particle formation by gas-phase pre-reactions in (100) MOVPE-grown β -Ga2O3films for vertical device application
2023, Chou, Ta-Shun, Seyidov, Palvan, Bin Anooz, Saud, Grüneberg, Raimund, Pietsch, Mike, Rehm, Jana, Tran, Thi Thuy Vi, Tetzner, Kornelius, Galazka, Zbigniew, Albrecht, Martin, Irmscher, Klaus, Fiedler, Andreas, Popp, Andreas
This work investigated the metalorganic vapor-phase epitaxy (MOVPE) of (100) β-Ga2O3 films with the aim of meeting the requirements to act as drift layers for high-power electronic devices. A height-adjustable showerhead achieving a close distance to the susceptor (1.5 cm) was demonstrated to be a critical factor in increasing the stability of the Ga wetting layer (or Ga adlayer) on the surface and reducing parasitic particles. A film thickness of up to 3 μm has been achieved while keeping the root mean square below 0.7 nm. Record carrier mobilities of 155 cm2 V-1 s-1 (2.2 μm) and 163 cm2 V-1 s-1 (3 μm) at room temperature were measured for (100) β-Ga2O3 films with carrier concentrations of 5.7 × 1016 and 7.1 × 1016 cm-3, respectively. Analysis of temperature-dependent Hall mobility and carrier concentration data revealed a low background compensating acceptor concentration of 4 × 1015 cm-3.
Cobalt as a promising dopant for producing semi-insulating β -Ga2O3crystals: Charge state transition levels from experiment and theory
2022, Seyidov, Palvan, Varley, Joel B., Galazka, Zbigniew, Chou, Ta-Shun, Popp, Andreas, Fiedler, Andreas, Irmscher, Klaus
Optical absorption and photoconductivity measurements of Co-doped β-Ga2O3 crystals reveal the photon energies of optically excited charge transfer between the Co related deep levels and the conduction or valence band. The corresponding photoionization cross sections are fitted by a phenomenological model considering electron-phonon coupling. The obtained fitting parameters: thermal ionization (zero-phonon transition) energy, Franck-Condon shift, and effective phonon energy are compared with corresponding values predicted by first principle calculations based on density functional theory. A (+/0) donor level ∼0.85 eV above the valence band maximum and a (0/-) acceptor level ∼2.1 eV below the conduction band minimum are consistently derived. Temperature-dependent electrical resistivity measurement at elevated temperatures (up to 1000 K) yields a thermal activation energy of 2.1 ± 0.1 eV, consistent with the position of the Co acceptor level. Furthermore, the results show that Co doping is promising for producing semi-insulating β-Ga2O3 crystals.
Refractory metal-based ohmic contacts on β-Ga2O3 using TiW
2022, Tetzner, Kornelius, Schewski, Robert, Popp, Andreas, Anooz, Saud Bin, Chou, Ta-Shun, Ostermay, Ina, Kirmse, Holm, Würfl, Joachim
The present work investigates the use of the refractory metal alloy TiW as a possible candidate for the realization of ohmic contacts to the ultrawide bandgap semiconductor β-Ga2O3. Ohmic contact properties were analyzed by transfer length measurements of TiW contacts annealed at temperatures between 400 and 900 °C. Optimum contact properties with a contact resistance down to 1.5 × 10-5 ω cm2 were achieved after annealing at 700 °C in nitrogen on highly doped β-Ga2O3. However, a significant contact resistance increase was observed at annealing temperatures above 700 °C. Cross-sectional analyses of the contacts using scanning transmission electron microscopy revealed the formation of a TiOx interfacial layer of 3-5 nm between TiW and β-Ga2O3. This interlayer features an amorphous structure and most probably possesses a high amount of vacancies and/or Ga impurities supporting charge carrier injection. Upon annealing at temperatures of 900 °C, the interlayer increases in thickness up to 15 nm, featuring crystalline-like properties, suggesting the formation of rutile TiO2. Although severe morphological changes at higher annealing temperatures were also verified by atomic force microscopy, the root cause for the contact resistance increase is attributed to the structural changes in thickness and crystallinity of the interfacial layer.