15 results
Search Results
Now showing 1 - 10 of 15
- ItemGrain-size distribution dataset of supercritical flow sediments from a Gilbert-type delta that are associated with disaggregation bands(Amsterdam [u.a.] : Elsevier, 2022) Tanner, David C.; Brandes, Christian; Winsemann, JuttaThis is a dataset of grain-size distribution in sub- and supercritical flow sediments of a Gilbert-type delta from an outcrop in North Germany. Thirteen samples of ca 2.5 kg were dried (at 105°C), and homogenised twice with a sample divider. A representative sample of 1-2 g was then analysed using laser diffraction. The grain-size distribution of the sand has a maximum between fine to medium sand, with a long fine fraction tail down to 0.06 µm and occasional coarse fractions (up to 1.5 mm) in some samples. Specific grain-size distributions correlate with the different sedimentary bedforms from which the samples were taken. This data is important for two reasons: Firstly, sedimentary structures formed by Froude supercritical flows are controlled by grain-size. However, few studies have provided grain-size datasets from the natural record, which often have a much wider grain-size distribution than experimentally-produced supercritical flow deposits. Secondly, the sands were deformed subsequently by disaggregation bands, a type of geological fault that only develops in porous granular materials, i.e. well-sorted, medium sand. The disaggregation bands are indicative of seismic or even aseismic, creeping movement of basement faults.
- ItemPredictability of properties of a fractured geothermal reservoir: the opportunities and limitations of an outcrop analogue study(Berlin ; Heidelberg [u.a.] : SpringerOpen, 2017) Bauer, Johanna F.; Krumbholz, Michael; Meier, Silke; Tanner, David C.Minimizing exploration risk in deep geothermics is of great economic importance. Especially, knowledge about temperature and permeability of the reservoir is essential. We test the potential of an outcrop analogue study to minimize uncertainties in prediction of the rock properties of a fractured reservoir in the Upper Rhine Graben. Our results show that although mineralogical composition, clay content, grain size, and fabric type are basically comparable, porosity and quartz cementation are not. Young’s modulus, as observed in the outcrop closest to the reservoir is about twice as high (~ 64 GPa) as observed in the reservoir (~ 34 GPa). Most importantly, however, the parameters that describe the fracture system, which are essential to predict reservoir permeability, differ significantly. While the outcrops are dominated by perpendicular fracture sets (striking NE–SW and NW–SE), two different conjugate fracture sets (striking NW–SE and N–S) occur in the reservoir. Fracture apertures, as reported from the FMI, are one order of magnitude wider than in the outcrop. We conclude that our outcrop analogue study fails to predict important properties of the reservoir (such as permeability and porosity). This must be in part because of the tectonically complex setting of the reservoir. We propose that analogue studies are important, but they must be treated with care when attempting to predict the controlling parameters of a fractured reservoir.
- ItemS-wave experiments for the exploration of a deep geothermal carbonate reservoir in the German Molasse Basin(Berlin ; Heidelberg [u.a.] : SpringerOpen, 2021) Wawerzinek, Britta; Buness, Hermann; von Hartmann, Hartwig; Tanner, David C.There are many successful geothermal projects that exploit the Upper Jurassic aquifer at 2–3 km depth in the German Molasse Basin. However, up to now, only P-wave seismic exploration has been carried out. In an experiment in the Greater Munich area, we recorded S-waves that were generated by the conventional P-wave seismic survey, using 3C receivers. From this, we built a 3D volume of P- to S-converted (PS) waves using the asymptotic conversion point approach. By combining the P-volume and the resulting PS-seismic volume, we were able to derive the spatial distribution of the vp/vs ratio of both the Molasse overburden and the Upper Jurassic reservoir. We found that the vp/vs ratios for the Molasse units range from 2.0 to 2.3 with a median of 2.15, which is much higher than previously assumed. This raises the depth of hypocenters of induced earthquakes in surrounding geothermal wells. The vp/vs ratios found in the Upper Jurassic vary laterally between 1.5 and 2.2. Since no boreholes are available for verification, we test our results against an independently derived facies classification of the conventional 3D seismic volume and found it correlates well. Furthermore, we see that low vp/vs ratios correlate with high vp and vs velocities. We interpret the latter as dolomitized rocks, which are connected with enhanced permeability in the reservoir. We conclude that 3C registration of conventional P-wave surveys is worthwhile.
- ItemWeibull-distributed dyke thickness reflects probabilistic character of host-rock strength([London] : Nature Publishing Group UK, 2014) Krumbholz, Michael; Hieronymus, Christoph F.; Burchardt, Steffi; Troll, Valentin R.; Tanner, David C.; Friese, NadineMagmatic sheet intrusions (dykes) constitute the main form of magma transport in the Earth’s crust. The size distribution of dykes is a crucial parameter that controls volcanic surface deformation and eruption rates and is required to realistically model volcano deformation for eruption forecasting. Here we present statistical analyses of 3,676 dyke thickness measurements from different tectonic settings and show that dyke thickness consistently follows the Weibull distribution. Known from materials science, power law-distributed flaws in brittle materials lead to Weibull-distributed failure stress. We therefore propose a dynamic model in which dyke thickness is determined by variable magma pressure that exploits differently sized host-rock weaknesses. The observed dyke thickness distributions are thus site-specific because rock strength, rather than magma viscosity and composition, exerts the dominant control on dyke emplacement. Fundamentally, the strength of geomaterials is scale-dependent and should be approximated by a probability distribution.
- ItemHigh‐resolution reflection seismics reveal the structure and the evolution of the Quaternary glacial Tannwald Basin(Oxford : Wiley, 2018) Burschil, Thomas; Buness, Hermann; Tanner, David C.; Wielandt‐Schuster, Ulrike; Ellwanger, Dietrich; Gabriel, GeraldOver-deepened basins exist throughout the Alpine realm. Improving our knowledge on these basins is of high social relevance, since these areas are often well-populated and they possess, for instance, unusual hydrological settings. Nonetheless, geophysical and sedimentological investigations of over-deepened basins are rare. We analyse the sedimentary succession of such a basin, the Tannwald Basin, through geological interpretation of seismic reflection profiles. The basin is located approximately 60 km north of the European Alps. It was incised into Tertiary molasse sediments by the Rhine Glacier and later filled by glacial, fluvial, and lacustrine deposits of 250 m thickness. The Leibniz Institute for Applied Geophysics acquired a grid of five high-resolution seismic reflection lines that imaged till the deepest parts of the Tannwald Basin. The seismic profiles, processed to a pre-stack depth migration level, allow a detailed geological interpretation that is calibrated with the help of a nearby borehole. We determine the structure and the seismic facies of the sediment succession in the basin and presume the following hypothesis of the evolution of the basin: sub-glacial erosion comprises the excavation of the over-deepened basin as well as detachment of large fragments of molasse material. These molasse slabs were deposited within the basin in a layer of basal till that graded upwards in water-lain till and fine-grained deposits. During the last two glaciations, the basinal structure became buried by till sequences and glacio-fluvial sediments.
- ItemStructural analysis of S-wave seismics around an urban sinkhole: evidence of enhanced dissolution in a strike-slip fault zone(Katlenburg-Lindau : European Geophysical Society, 2017-12-19) Wadas, Sonja H.; Tanner, David C.; Polom, Ulrich; Krawczyk, Charlotte M.In November 2010, a large sinkhole opened up in the urban area of Schmalkalden, Germany. To determine the key factors which benefited the development of this collapse structure and therefore the dissolution, we carried out several shear-wave reflection-seismic profiles around the sinkhole. In the seismic sections we see evidence of the Mesozoic tectonic movement in the form of a NW–SE striking, dextral strike-slip fault, known as the Heßleser Fault, which faulted and fractured the subsurface below the town. The strike-slip faulting created a zone of small blocks ( < 100 m in size), around which steep-dipping normal faults, reverse faults and a dense fracture network serve as fluid pathways for the artesian-confined groundwater. The faults also acted as barriers for horizontal groundwater flow perpendicular to the fault planes. Instead groundwater flows along the faults which serve as conduits and forms cavities in the Permian deposits below ca. 60 m depth. Mass movements and the resulting cavities lead to the formation of sinkholes and dissolution-induced depressions. Since the processes are still ongoing, the occurrence of a new sinkhole cannot be ruled out. This case study demonstrates how S-wave seismics can characterize a sinkhole and, together with geological information, can be used to study the processes that result in sinkhole formation, such as a near-surface fault zone located in soluble rocks. The more complex the fault geometry and interaction between faults, the more prone an area is to sinkhole occurrence.
- ItemMulti-stage emplacement of the Götemar Pluton, SE Sweden: new evidence inferred from field observations and microfabric analysis, including cathodoluminescence microscopy(Berlin ; Heidelberg : Springer, 2012) Friese, Nadine; Vollbrecht, Axel; Tanner, David C.; Fahlbusch, Wiebke; Weidemann, MiriamThe emplacement of the Mesoproterozoic Götemar Pluton into Paleoproterozoic granitoid host rocks of the Transscandinavian Igneous Belt is re-examined by microfabric analysis, including cathodoluminescence microscopy. Field data on the pluton-host rock system are used to strengthen the model. The Götemar Pluton, situated on the Baltic Shield of SE Sweden, is a horizontally zoned tabular structure that was constructed by the intrusion of successive pulses of magma with different crystal/melt ratios, at an estimated crustal depth of 4–8 km. Initial pluton formation involved magma ascent along a vertical dike, which was arrested at a mechanical discontinuity within the granitoid host rocks; this led to the formation of an initial sill. Subsequent sill stacking and their constant inflation resulted in deformation and reheating of existing magma bodies, which also raised the pluton roof. This multi-stage emplacement scenario is indicated by complex dike relationships and the occurrence of several generations of quartz (Si-metasomatism). The sills were charged by different domains of a heterogeneous magma chamber with varying crystal/melt ratios. Ascent or emplacement of magma with a high crystal/melt ratio is indicated by syn-magmatic deformation of phenocrysts. Complex crystallization fabrics (e.g. oscillatory growth zoning caused by high crystal defect density, overgrowth and replacement features, resorbed and corroded crystal cores, rapakivi structure) are mostly related to processes within the main chamber, that is repeated magma mixing or water influx.
- ItemNear-surface fault detection using high-resolution shear wave reflection seismics at the CO2CRC Otway Project site, Australia(Hoboken, NJ : Wiley, 2016) Beilecke, Thies; Krawczyk, Charlotte M.; Ziesch, Jennifer; Tanner, David C.High-resolution, near-surface, shear wave reflection seismic measurements were carried out in November 2013 at the CO2CRC Otway Project site, Victoria, Australia, with the aim to determine whether and, if so, where deeper faults reach the near subsurface. From a previous P wave 3-D reflection seismic data set that was concentrated on a reservoir at 2 km depth, we can only interpret faults up to 400 m below sea level. For the future monitoring in the overburden of the CO2 reservoir it is important to know whether and how the faults continue in the subsurface. We prove that two regional fault zones do in fact reach the surface instead of dying out at depth. Individual first-break signatures in the shot gathers along the profiles support this interpretation. However, this finding does not imply perforce communication between the reservoir and the surface in the framework of CO2 injection. The shear wave seismic sections are complementary to existing P wave volumes. They image with high resolution (better than 3 m vertically) different tectonic structures. Similar structures also outcrop on the southern coast of the Otway Basin. Both the seismic and the outcrops evidence the complex youngest structural history of the area.
- ItemInitiation and development of normal faults within the German alpine foreland basin: The inconspicuous role of basement structures(Hoboken, NJ : Wiley, 2016) Hartmann, Hartwig von; Tanner, David C.; Schumacher, SandraIn a large seismic cube within the German Alpine Molasse Basin, we recognize large normal faults with lateral alternating dips that displace the Molasse sediments. They are disconnected but strike parallel to fault lineaments of the underlying carbonate platform. This raises the question how such faults could independently develop. Structural analysis suggests that the faults grew both upward and downward from the middle of the Molasse package, i.e., they newly initiated within the Molasse sediments and were not caused by reactivation of the faults in the carbonate platform and/or crystalline basement. Numerical modeling of the basin proves that temporarily and spatially confined extensional stresses existed within the Molasse sediments but not in the carbonate platform and basement during lithospheric bending. The workflow shown here gives a new and as yet undocumented insight in the tectonic and structural processes within a foreland basin that was affected by buckling and bending in front of the orogen.
- ItemEvaluation of deep crustal earthquakes in northern Germany - Possible tectonic causes(Oxford [u.a.] : Wiley-Blackwell, 2019) Brandes, Christian; Plenefisch, Thomas; Tanner, David C.; Gestermann, Nicolai; Steffen, HolgerWe present new evidence for seven deep crustal, intraplate earthquakes in northern Germany, a region regarded as an area of low seismicity. From 2000 to 2018, seven earthquakes with magnitudes of ML 1.3–3.1, were detected at depths of 17.0–31.4 km. By placing the earthquake hypocentres in a geological three-dimensional model, we can correlate two of the earthquakes with the Thor Suture, a major fault zone in this area. Five of the earthquakes group in the lower crust near the Moho, which implies that parts of the lower crust and the crust/mantle boundary in northern Germany act as a structural discontinuity on which deformation localizes. Numerical simulation implies that stress changes due to glacial isostatic adjustment most likely triggered these deep crustal earthquakes.