8 results
Search Results
Now showing 1 - 8 of 8
- ItemAnalysing Interlinked Frequency Dynamics of the Urban Acoustic Environment(Basel : MDPI AG, 2022) Haselhoff, Timo; Braun, Tobias; Hornberg, Jonas; Lawrence, Bryce T.; Ahmed, Salman; Gruehn, Dietwald; Moebus, SusanneAs sustainable metropolitan regions require more densely built-up areas, a comprehensive understanding of the urban acoustic environment (AE) is needed. However, comprehensive datasets of the urban AE and well-established research methods for the AE are scarce. Datasets of audio recordings tend to be large and require a lot of storage space as well as computationally expensive analyses. Thus, knowledge about the long-term urban AE is limited. In recent years, however, these limitations have been steadily overcome, allowing a more comprehensive analysis of the urban AE. In this respect, the objective of this work is to contribute to a better understanding of the time-frequency domain of the urban AE, analysing automatic audio recordings from nine urban settings over ten months. We compute median power spectra as well as normalised spectrograms for all settings. Additionally, we demonstrate the use of frequency correlation matrices (FCMs) as a novel approach to access large audio datasets. Our results show site-dependent patterns in frequency dynamics. Normalised spectrograms reveal that frequency bins with low power hold relevant information and that the AE changes considerably over a year. We demonstrate that this information can be captured by using FCMs, which also unravel communities of interlinked frequency dynamics for all settings.
- ItemPreventing airborne transmission of SARS-CoV-2 in hospitals and nursing homes(Basel : MDPI AG, 2020) Ahlawat, Ajit; Mishra, Sumit Kumar; Birks, John W.; Costabile, Francesca; Wiedensohler, Alfred[No abstract available]
- ItemAwareness, Experience, and Knowledge of Farming Households in Rural Bangladesh Regarding Mold Contamination of Food Crops: A Cross-Sectional Study(Basel : MDPI AG, 2021) Kyei, Nicholas N. A.; Waid, Jillian L; Ali, Nurshad; Gabrysch, SabineAside from specific environmental conditions, poor agricultural practices contribute to mold and thus the mycotoxin contamination of crops. This study investigated Bangladeshi farming households’ (i) awareness of and experience with mold contamination of food crops; (ii) knowledge and awareness of the timing, causes, and consequences of mold and mycotoxin contamination; and (iii) knowledge of the recommended agricultural practices for controlling and preventing mold contamination of food crops. A survey was conducted with 1280 households in rural areas of Habiganj district, Bangladesh. Basic descriptive statistics were calculated, and mixed-effects linear regression analyses were performed to examine associations between household characteristics and overall knowledge scores. The awareness of mold contamination of food crops was very high (99%; 95% CI: 98–100%) and a shared experience among households (85%; 95% CI: 80–88%). Yet, the majority (80%; 95% CI: 76–84%) demonstrated a low level of knowledge of the timing, causes, and preventive practices regarding mold contamination of crops. Knowledge scores were similar over demographic groups and better for households with more arable land. The findings suggest a generally insufficient knowledge of the conditions that favor mold contamination and the measures for preventing mold contamination of food crops. These findings underline the need for tailored interventions to promote good agricultural practices and reduce mold contamination of food crops.
- ItemPhysico-Chemical Properties and Deposition Potential of PM2.5 during Severe Smog Event in Delhi, India(Basel : MDPI AG, 2022) Fatima, Sadaf; Mishra, Sumit Kumar; Ahlawat, Ajit; Dimri, Ashok PriyadarshanThe present work studies a severe smog event that occurred in Delhi (India) in 2017, targeting the characterization of PM2.5 and its deposition potential in human respiratory tract of different population groups in which the PM2.5 levels raised from 124.0 µg/m3 (pre-smog period) to 717.2 µg/m3 (during smog period). Higher concentration of elements such as C, N, O, Na, Mg, Al, Si, S, Fe, Cl, Ca, Ti, Cr, Pb, Fe, K, Cu, Cl, P, and F were observed during the smog along with dominant organic functional groups (aldehyde, ketones, alkyl halides (R-F; R-Br; R-Cl), ether, etc.), which supported potential contribution from transboundary biomass-burning activities along with local pollution sources and favorable meteorological conditions. The morphology of individual particles were found mostly as non-spherical, including carbon fractals, aggregates, sharp-edged, rod-shaped, and flaky structures. A multiple path particle dosimetry (MPPD) model showed significant deposition potential of PM2.5 in terms of deposition fraction, mass rate, and mass flux during smog conditions in all age groups. The highest PM2.5 deposition fraction and mass rate were found for the head region followed by the alveolar region of the human respiratory tract. The highest mass flux was reported for 21-month-old (4.7 × 102 µg/min/m2), followed by 3-month-old (49.2 µg/min/m2) children, whereas it was lowest for 21-year-old adults (6.8 µg/min/m2), indicating babies and children were more vulnerable to PM2.5 pollution than adults during smog. Deposition doses of toxic elements such as Cr, Fe, Zn, Pb, Cu, Mn, and Ni were also found to be higher (up to 1 × 10−7 µg/kg/day) for children than adults.
- ItemOne-shot phase-recovery using a cellphone RGB camera on a Jamin-Lebedeff microscope(San Francisco, California, US : PLOS, 2019) Diederich, Benedict; Marsikova, Barbora; Amos, Brad; Heintzmann, RainerJamin-Lebedeff (JL) polarization interference microscopy is a classical method for determining the change in the optical path of transparent tissues. Whilst a differential interference contrast (DIC) microscopy interferes an image with itself shifted by half a point spread function, the shear between the object and reference image in a JL-microscope is about half the field of view. The optical path difference (OPD) between the sample and reference region (assumed to be empty) is encoded into a color by white-light interference. From a color-table, the Michel-Levy chart, the OPD can be deduced. In cytology JL-imaging can be used as a way to determine the OPD which closely corresponds to the dry mass per area of cells in a single image. Like in other interference microscopy methods (e.g. holography), we present a phase retrieval method relying on single-shot measurements only, thus allowing real-time quantitative phase measurements. This is achieved by adding several customized 3D-printed parts (e.g. rotational polarization-filter holders) and a modern cellphone with an RGB-camera to the Jamin-Lebedeff setup, thus bringing an old microscope back to life. The algorithm is calibrated using a reference image of a known phase object (e.g. optical fiber). A gradient-descent based inverse problem generates an inverse look-up-table (LUT) which is used to convert the measured RGB signal of a phase-sample into an OPD. To account for possible ambiguities in the phase-map or phase-unwrapping artifacts we introduce a total-variation based regularization. We present results from fixed and living biological samples as well as reference samples for comparison.
- ItemRadio Frequency CMOS Chem-bio Viscosity Sensors based on Dielectric Spectroscopy([Setúbal] : SCITEPRESS - Science and Technology Publications, Lda., 2017) Guha, Subhajit; Wenger, Christian; Peixoto, Nathalia; Fred, Ana; Gamboa, Hugo; Vaz, MárioThis paper presents a CMOS Radio frequency dielectric sensor platform for the detection of relative viscosity changes in a fluid sample. The operating frequency of the sensor is 12.28 GHz. This frequency range has been chosen for high signal to noise ratio and also to avoid other low frequency dispersion mechanisms for future lab on chip applications. The sensor chip has been fabricated in 250 nm BiCMOS technology of IHP. The measurements conducted to show the relative viscosity variation detection capability of the sensor chip, were based on mixtures of glycerol and water as well as glycerol and organic alcohol. The detection limit of viscosity is dependent on the permittivity contrast of the sample constituent. Therefore, it is also shown the choice of frequency inherently aids in the permittivity contrast of the sample constituents.
- ItemBiomedical sensing and imaging with optical fibers—Innovation through convergence of science disciplines(College Park : American Institute of Physics, 2018) Li, Jiawen; Ebendorff-Heidepriem, Heike; Gibson, Brant C.; Greentree, Andrew D.; Hutchinson, Mark R.; Jia, Peipei; Kostecki, Roman; Liu, Guozhen; Orth, Antony; Ploschner, Martin; Schartner, Erik P.; Warren-Smith, Stephen C.; Zhang, Kaixin; Tsiminis, Georgios; Goldys, EwaThe probing of physiological processes in living organisms is a grand challenge that requires bespoke analytical tools. Optical fiber probes offer a minimally invasive approach to report physiological signals from specific locations inside the body. This perspective article discusses a wide range of such fiber probes developed at the Australian Research Council Centre of Excellence for Nanoscale BioPhotonics. Our fiber platforms use a range of sensing modalities, including embedded nanodiamonds for magnetometry, interferometric fiber cavities for refractive index sensing, and tailored metal coatings for surface plasmon resonance sensing. Other fiber probes exploit molecularly sensitive Raman scattering or fluorescence where optical fibers have been combined with chemical and immunosensors. Fiber imaging probes based on interferometry and computational imaging are also discussed as emerging in vivo diagnostic devices. We provide examples to illustrate how the convergence of multiple scientific disciplines generates opportunities for the fiber probes to address key challenges in real-time in vivo diagnostics. These future fiber probes will enable the asking and answering of scientific questions that were never possible before.
- ItemFunctionalization of Ti-40Nb implant material with strontium by reactive sputtering(London : BioMed Central, 2017-10-10) Göttlicher, Markus; Rohnke, Marcus; Moryson, Yannik; Thomas, Jürgen; Sann, Joachim; Lode, Anja; Schumacher, Matthias; Schmidt, Romy; Pilz, Stefan; Gebert, Annett; Gemming, Thomas; Janek, JürgenBackground: Surface functionalization of orthopedic implants with pharmaceutically active agents is a modern approach to enhance osseointegration in systemically altered bone. A local release of strontium, a verified bone building therapeutic agent, at the fracture site would diminish side effects, which could occur otherwise by oral administration. Strontium surface functionalization of specially designed titanium-niobium (Ti-40Nb) implant alloy would provide an advanced implant system that is mechanically adapted to altered bone with the ability to stimulate bone formation. Methods: Strontium-containing coatings were prepared by reactive sputtering of strontium chloride (SrCl2) in a self-constructed capacitively coupled radio frequency (RF) plasma reactor. Film morphology, structure and composition were investigated by scanning electron microscopy (SEM), time of flight secondary ion mass spectrometry (ToF-SIMS) and X-ray photoelectron spectroscopy (XPS). High-resolution transmission electron microscopy (HR-TEM) was used for the investigation of thickness and growth direction of the product layer. TEM lamellae were prepared using the focused ion beam (FIB) technique. Bioactivity of the surface coatings was tested by cultivation of primary human osteoblasts and subsequent analysis of cell morphology, viability, proliferation and differentiation. The results are correlated with the amount of strontium that is released from the coating in biomedical buffer solution, quantified by inductively coupled plasma mass spectrometry (ICP-MS). Results: Dense coatings, consisting of SrOxCly, of more than 100 nm thickness and columnar structure, were prepared. TEM images of cross sections clearly show an incoherent but well-structured interface between coating and substrate without any cracks. Sr2+ is released from the SrOxCly coating into physiological solution as proven by ICP-MS analysis. Cell culture studies showed excellent biocompatibility of the functionalized alloy. Conclusions: Ti-40Nb alloy, a potential orthopedic implant material for osteoporosis patients, could be successfully plasma coated with a dense SrOxCly film. The material performed well in in vitro tests. Nevertheless, the Sr2+ release must be optimized in future work to meet the requirements of an effective drug delivery system.