3 results
Search Results
Now showing 1 - 3 of 3
- ItemIntercomparison of 15 aerodynamic particle size spectrometers (APS 3321): Uncertainties in particle sizing and number size distribution(München : European Geopyhsical Union, 2016) Pfeifer, Sascha; Müller, Thomas; Weinhold, Kay; Zikova, Nadezda; dos Santos, Sebastiao Martins; Marinoni, Angela; Bischof, Oliver F.; Kykal, Carsten; Ries, Ludwig; Meinhardt, Frank; Aalto, Pasi; Mihalopoulos, Nikolaos; Wiedensohler, AlfredAerodynamic particle size spectrometers are a well-established method to measure number size distributions of coarse mode particles in the atmosphere. Quality assurance is essential for atmospheric observational aerosol networks to obtain comparable results with known uncertainties. In a laboratory study within the framework of ACTRIS (Aerosols, Clouds, and Trace gases Research Infrastructure Network), 15 aerodynamic particle size spectrometers (APS model 3321, TSI Inc., St. Paul, MN, USA) were compared with a focus on flow rates, particle sizing, and the unit-to-unit variability of the particle number size distribution. Flow rate deviations were relatively small (within a few percent), while the sizing accuracy was found to be within 10 % compared to polystyrene latex (PSL) reference particles. The unit-to-unit variability in terms of the particle number size distribution during this study was within 10 % to 20 % for particles in the range of 0.9 up to 3 µm, which is acceptable for atmospheric measurements. For particles smaller than that, the variability increased up to 60 %, probably caused by differences in the counting efficiencies of individual units. Number size distribution data for particles smaller than 0.9 µm in aerodynamic diameter should only be used with caution. For particles larger than 3 µm, the unit-to-unit variability increased as well. A possible reason is an insufficient sizing accuracy in combination with a steeply sloping particle number size distribution and the increasing uncertainty due to decreasing counting. Particularly this uncertainty of the particle number size distribution must be considered if higher moments of the size distribution such as the particle volume or mass are calculated, which require the conversion of the aerodynamic diameter measured to a volume equivalent diameter. In order to perform a quantitative quality assurance, a traceable reference method for the particle number concentration in the size range 0.5–3 µm is needed.
- ItemHygroscopic properties of aerosol particles in the northeastern Atlantic during ACE-2(Milton Park : Taylor & Francis, 2016) Swietlicki, Erik; Zhou, Jingchuan; Covert, David S.; Hämeri, Kaarle; Busch, Bernhard; Väkeva, Minna; Dusek, Ulrike; Berg, Olle H.; Wiedensohler, Alfred; Aalto, Pasi; Mäkelä, Jyrki; Martinsson, Bengt G.; Papaspiropoulos, Giorgos; Mentes, Besim; Frank, Göran; Stratmann, FrankMeasurements of the hygroscopic properties of sub-micrometer atmospheric aerosol particles were performed with hygroscopic tandem differential mobility analysers (H-TDMA) at 5 sites in the subtropical north-eastern Atlantic during the second Aerosol Characterization Experiment (ACE-2) from 16 June to 25 July 1997. Four of the sites were in the marine boundary layer and one was, at least occasionally, in the lower free troposphere. The hygroscopic diameter growth factors of individual aerosol particles in the dry particle diameter range 10−440 nm were generally measured for changes in relative humidity (RH) from <10% to 90%. In the marine boundary layer, growth factors at 90% RH were dependent on location, air mass type and particle size. The data was dominated by a unimodal growth distribution of more-hygroscopic particles, although a bimodal growth distribution including less-hygroscopic particles was observed at times, most often in the more polluted air masses. In clean marine air masses the more-hygroscopic growth factors ranged from about 1.6 to 1.8 with a consistent increase in growth factor with increasing particle size. There was also a tendency toward higher growth factors as sodium to sulphate molar ratio increased with increasing sea-salt contribution at higher wind speeds. During outbreaks of European pollution in the ACE-2 region, the growth factors of the largest particles were reduced, but only slightly. Growth factors at all sizes in both clean and polluted air masses were markedly lower at the Sagres, Portugal site due to more proximate continental influences. The frequency of occurrence of less-hygroscopic particles with a growth factor of ca. 1.15 was greatest during polluted conditions at Sagres. The free tropospheric 50 nm particles were predominately less-hygroscopic, with an intermediate growth factor of 1.4, but more-hygroscopic particles with growth factors of about 1.6 were also frequent. While these particles probably originate from within the marine boundary layer, the less-hygroscopic particles are probably more characteristic of lower free tropospheric air masses. For those occasions when measurements were made at 90% and an intermediate 60% or 70% RH, the growth factor G(RH) of the more-hygroscopic particles could be modelled empirically by a power law expression. For the ubiquitous more-hygroscopic particles, the expressions G(RH)=(1-RH/100)-0.210 for 50 nm Aitken mode particles and G(RH)=(1-RH/100)-0.233 for 166 nm accumulation mode particles are recommended for clean marine air masses in the north-eastern Atlantic within the range 0
- ItemOccurrence of an ultrafine particle mode less than 20 nm in diameter in the marine boundary layer during Arctic summer and autumn(Milton Park : Taylor & Francis, 2017) Wiedensohler, Alfred; Covert, David S.; Swietlicki, Erik; Aalto, Pasi; Heintzenberg, Jost; Leck, CarolineThe International Arctic Ocean Expedition 1991 (IAOE-91) provided a platform to study the occurrence and size distributions of ultrafine particles in the marine boundary layer (MBL) during Arctic summer and autumn. Measurements of both aerosol physics, and gas/particulate chemistry were taken aboard the Swedish icebreaker Oden. Three separate submicron aerosol modes were found: an ultrafine mode (Dp < 20 nm), the Aitken mode (20 < Dp < 100 nm), and the accumulation mode (Dp > 100 nm). We evaluated correlations between ultrafine particle number concentrations and mean diameter with the entire measured physical, chemical, and meteorological data set. Multivariate statistical methods were then used to make these comparisons. A principal component (PC) analysis indicated that the observed variation in the data could be explained by the influence from several types of air masses. These were characterised by contributions from the open sea or sources from the surrounding continents and islands. A partial least square (PLS) regression of the ultrafine particle concentration was also used. These results implied that the ultrafine particles were produced above or in upper layers of the MBL and mixed downwards. There were also indications that the open sea acted as a source of the precursors for ultrafine particle production. No anti-correlation was found between the ultrafine and accumulation particle number concentrations, thus indicating that the sources were in separate air masses.