Search Results
Stability and excitation dynamics of an argon micro-scaled atmospheric pressure plasma jet
A megahertz-driven plasma jet at atmospheric pressure—the so-called micro-scaled atmospheric pressure plasma jet (μAPPJ)—operating in pure argon has been investigated experimentally and by numerical modelling. To ignite the discharge in argon within the jet geometry, a self-made plasma tuning unit was designed, which additionally enables measurements of the dissipated power in the plasma itself. Discharges in the α-mode up to their transition to the γ-mode were studied experimentally for varying frequencies. It was found that the voltage at the α–γ transition behaves inversely proportional to the applied frequency f and that the corresponding power scales with an f 3/2law. Both these findings agree well with the results of time-dependent, spatially one-dimensional fluid modelling of the discharge behaviour, where the f 3/2 scaling of the α–γ transition power is additionally verified by the established concept of a critical plasma density for sheath breakdown. Furthermore, phase resolved spectroscopy of the optical emission at 750.39 nm as well as at 810.37 nm and 811.53 nm was applied to analyse the excitation dynamics of the discharge at 27 MHz for different applied powers. The increase of the power leads to an additional maximum in the excitation structure of the 750.39 nm line emission at the α–γ transition point, whereas the emission structure around 811 nm does not change qualitatively. According to the fluid modelling results, this differing behaviour originates from the different population mechanisms of the corresponding energy levels of argon.
Influence of surface parameters on dielectric-barrier discharges in argon at subatmospheric pressure
The influence of the secondary electron emission coefficient, γ, and the relative permittivity, ɛr, of the dielectric layers on the characteristics of dielectric-barrier discharges (DBDs) is studied by means of numerical modelling and calculated results are compared with experimental data. The analysis has been performed for a geometrically symmetric, plane-parallel DBD in argon with copper electrodes covered by quartz dielectrics. A time-dependent, spatially one-dimensional fluid model involving the drift-diffusion approximation is applied for the numerical analysis of the DBD operating sinusoidally at a frequency of 24 kHz with applied voltages between 1.8 and 3.4 kV and pressures from 100 to 650 mbar. Main features of the model as well as the experimental setup and procedures are given. The modelling studies show especially the sensitivity of the results on the specific choice of γ and ɛr regarding the occurrence and intensity of discharge peaks, the appearance of one or more smaller peaks after the main peak, as well the establishment of a single periodic, multiperiodic or even chaotic temporal evolution of the DBD. In particular, generally good agreement between measured and calculated discharge current signals and the power dissipated in the discharge is found for γ = 0.02 and ɛr = 4.2.