Search Results
Influence of dielectric thickness and electrode structure on the ion wind generation by micro fabricated plasma actuators
Surface dielectric barrier discharges are investigated in order to explore the combined effects of barrier thickness and microstructure of the exposed electrode on the ion wind generation. Actuators with straight and structured high voltage electrodes with characteristic sizes of 200 and 250 µm and dielectric thicknesses of 0.5, 1 and 2 mm are compared. It is observed that: i) actuator efficiency of ion wind generation strongly depends on the applied voltage amplitude; ii) operation voltage depends on the dielectric thickness logarithmically; iii) electrode microstructure slightly increases the dynamic pressure (few percent in maximum), however the effect decreases with thicker dielectrics and smaller electrode structures; iv) the pattern of the most intensive discharge parts as well as the dielectric erosion repeats the regular structure of the electrodes down to 200 µm. Several identical samples are tested during different days to estimate the impact of the air humidity and the degradation of the dielectric. The microscale precision of the sample manufacture was accomplished by a commercial facility for printed circuit boards. © 2020 The Author(s). Published by IOP Publishing Ltd.
Upscaling from single- to multi-filament dielectric barrier discharges in pulsed operation
A study on the scalability of discharge characteristics of a single-filament dielectric barrier discharge (DBD) to a spatially one-dimensional multi-filament arrangement driven by the same high-voltage (HV) pulses was performed for a gas mixture of 0.1 vol% O2 in N2 at 1 bar. Both arrangements feature a 1 mm gap with dielectric-covered electrodes featuring two hemispherical alumina caps for the single-filament and two parallel alumina-tubes for the multi-filament arrangement. The DBDs were characterised by electrical measurements (for peak current, energy, and power) accompanied by iCCD and streak imaging to determine the filament number and the discharge development in the gas gap and on the surfaces. It was found that the electrical quantities scale with a constant factor between the single- and multi-filament arrangement, which is expected to be related to the filament number. In the multi-filament arrangement, the pulsed operation leads to filament formation in the entire gap in lateral direction within less than 2 ns. Furthermore, particular breakdown or discharge inception regimes were identified for the multi-filament DBDs. These regimes could be generated at the falling slope of asymmetrical HV pulses featuring e.g. a double-streamer propagation, which was previously reported for single-filament DBDs. Consequently, it was proven that the discharge manipulation by varying the HV pulse widths obtained for single-filament DBDs can also be applied in a one-dimensional multi-filament arrangement, i.e. an upscaling based on the knowledge for single-filament DBDs seems to be generally possible.