3 results
Search Results
Now showing 1 - 3 of 3
- ItemVertical distribution of aerosol optical properties in the Po Valley during the 2012 summer campaigns(Katlenburg-Lindau : EGU, 2018) Bucci, Silvia; Cristofanelli, Paolo; Decesari, Stefano; Marinoni, Angela; Sandrini, Silvia; Größ, Johannes; Wiedensohler, Alfred; Di Marco, Chiara F.; Nemitz, Eiko; Cairo, Francesco; Di Liberto, Luca; Fierli, FedericoStudying the vertical distribution of aerosol particle physical and chemical properties in the troposphere is essential to understand the relative importance of local emission processes vs. long-range transport for column-integrated aerosol properties (e.g. the aerosol optical depth, AOD, affecting regional climate) as well as for the aerosol burden and its impacts on air quality at the ground. The main objective of this paper is to investigate the transport of desert dust in the middle troposphere and its intrusion into the planetary boundary layer (PBL) over the Po Valley (Italy), a region considered one of the greatest European pollution hotspots for the frequency that particulate matter (PM) limit values are exceeded. Events of mineral aerosol uplift from local (soil) sources and phenomena of hygroscopic growth at the ground are also investigated, possibly affecting the PM concentration in the region as well. During the PEGASOS 2012 field campaign, an integrated observing-modelling system was set up based on near-surface measurements (particle concentration and chemistry), vertical profiling (backscatter coefficient profiles from lidar and radiosoundings) and Lagrangian air mass transport simulations by FLEXPART model. Measurements were taken at the San Pietro Capofiume supersite (44°39′ĝ€N, 11°37′ĝ€E; 11ĝ€mĝ€a.s.l.), located in a rural area relatively close to some major urban and industrial emissive areas in the Po Valley. Mt. Cimone (44°12′ĝ€N, 10°42′ĝ€E; 2165ĝ€mĝ€a.s.l.) WMO/GAW station observations are also included in the study to characterize regional-scale variability. Results show that, in the Po Valley, aerosol is detected mainly below 2000ĝ€mĝ€a.s.l. with a prevalent occurrence of non-depolarizing particles ( > 50ĝ€% throughout the campaign) and a vertical distribution modulated by the PBL daily evolution. Two intense events of mineral dust transport from northern Africa (19-21 and 29 June to 2 July) are observed, with layers advected mainly above 2000ĝ€m, but subsequently sinking and mixing in the PBL. As a consequence, a non-negligible occurrence of mineral dust is observed close to the ground ( ĝ1/4 7ĝ€% of occurrence during a 1-month campaign). The observations unambiguously show Saharan dust layers intruding the Po Valley mixing layer and directly affecting the aerosol concentrations near the surface. Finally, lidar observations also indicate strong variability in aerosol on shorter timescales (hourly). Firstly, these highlight events of hygroscopic growth of anthropogenic aerosol, visible as shallow layers of low depolarization near the ground. Such events are identified during early morning hours at high relative humidity (RH) conditions (RHĝ€ > 80ĝ€%). The process is observed concurrently with high PM1 nitrate concentration (up to 15ĝ€μgĝ€cmĝ'3) and hence mainly explicable by deliquescence of fine anthropogenic particles, and during mineral dust intrusion episodes, when water condensation on dust particles could instead represent the dominant contribution. Secondly, lidar images show frequent events (mean daily occurrence of ĝ1/4 ĝ€22ĝ€% during the whole campaign) of rapid uplift of mineral depolarizing particles in afternoon-evening hours up to 2000ĝ€mĝ€a.s.l. height. The origin of such particles cannot be directly related to long-range transport events, being instead likely linked to processes of soil particle resuspension from agricultural lands.
- ItemFirst results of the "Carbonaceous Aerosol in Rome and Environs (CARE)" Experiment: Beyond current standards for PM10(Basel, Switzerland : MDPI AG, 2017) Costabile, Francesca; Alas, Honey; Aufderheide, Michaela; Avino, Pasquale; Amato, Fulvio; Argentini, Stefania; Barnaba, Francesca; Berico, Massimo; Bernardoni, Vera; Biondi, Riccardo; Casasanta, Giampietro; Ciampichetti, Spartaco; Calzolai, Giulia; Canepari, Silvia; Conidi, Alessandro; Cordelli, Eugenia; Di Ianni, Antonio; Di Liberto, Luca; Facchini, Maria Cristina; Facci, Andrea; Frasca, Daniele; Gilardoni, Stefania; Grollino, Maria Giuseppa; Gualtieri, Maurizio; Lucarelli, Franco; Malaguti, Antonella; Manigrasso, Maurizio; Montagnoli, Mauro; Nava, Silvia; Perrino, Cinzia; Padoan, Elio; Petenko, Igor; Querol, Xavier; Simonetti, Giulia; Tranfo, Giovanna; Ubertini, Stefano; Valli, Gianluigi; Valentini, Sara; Vecchi, Roberta; Volpi, Francesca; Weinhold, Kay; Wiedensohler, Alfred; Zanini, Gabriele; Gobbi, Gian Paolo; Petralia, EttoreIn February 2017 the “Carbonaceous Aerosol in Rome and Environs (CARE)” experiment was carried out in downtown Rome to address the following specific questions: what is the color, size, composition, and toxicity of the carbonaceous aerosol in the Mediterranean urban background area of Rome? The motivation of this experiment is the lack of understanding of what aerosol types are responsible for the severe risks to human health posed by particulate matter (PM) pollution, and how carbonaceous aerosols influence radiative balance. Physicochemical properties of the carbonaceous aerosol were characterised, and relevant toxicological variables assessed. The aerosol characterisation includes: (i) measurements with high time resolution (min to 1–2 h) at a fixed location of black carbon (eBC), elemental carbon (EC), organic carbon (OC), particle number size distribution (0.008–10 μm), major non refractory PM1 components, elemental composition, wavelength-dependent optical properties, and atmospheric turbulence; (ii) 24-h measurements of PM10 and PM2.5 mass concentration, water soluble OC and brown carbon (BrC), and levoglucosan; (iii) mobile measurements of eBC and size distribution around the study area, with computational fluid dynamics modeling; (iv) characterisation of road dust emissions and their EC and OC content. The toxicological assessment includes: (i) preliminary evaluation of the potential impact of ultrafine particles on lung epithelia cells (cultured at the air liquid interface and directly exposed to particles); (ii) assessment of the oxidative stress induced by carbonaceous aerosols; (iii) assessment of particle size dependent number doses deposited in different regions of the human body; (iv) PAHs biomonitoring (from the participants into the mobile measurements). The first experimental results of the CARE experiment are presented in this paper. The objective here is to provide baseline levels of carbonaceous aerosols for Rome, and to address future research directions. First, we found that BC and EC mass concentration in Rome are larger than those measured in similar urban areas across Europe (the urban background mass concentration of eBC in Rome in winter being on average 2.6 ± 2.5 μg · m−3, mean eBC at the peak level hour being 5.2 (95% CI = 5.0–5.5) μg · m−3 ). Then, we discussed significant variations of carbonaceous aerosol properties occurring with time scales of minutes, and questioned on the data averaging period used in current air quality standard for PM10 (24-h). Third, we showed that the oxidative potential induced by aerosol depends on particle size and composition, the effects of toxicity being higher with lower mass concentrations and smaller particle size. Albeit this is a preliminary analysis, findings reinforce the need for an urgent update of existing air quality standards for PM10 and PM2.5 with regard to particle composition and size distribution, and data averaging period. Our results reinforce existing concerns about the toxicity of carbonaceous aerosols, support the existing evidence indicating that particle size distribution and composition may play a role in the generation of this toxicity, and remark the need to consider a shorter averaging period (<1 h) in these new standards.
- ItemBlack carbon aerosol in Rome (Italy): Inference of a long-term (2001-2017) record and related trends from AERONET sun-photometry data(Basel, Switzerland : MDPI AG, 2018) Di Ianni, Antonio; Costabile, Francesca; Barnaba, Francesca; Di Liberto, Luca; Weinhold, Kay; Wiedensohler, Alfred; Struckmeier, Caroline; Drewnick, Frank; Gobbi, Gian PaoloSurface concentration of black carbon (BC) is a key factor for the understanding of the impact of anthropogenic pollutants on human health. The majority of Italian cities lack long-term measurements of BC concentrations since such a metric is not regulated by EU legislation. This work attempts a long-term (2001–2017) inference of equivalent black carbon (eBC) concentrations in the city of Rome (Italy) based on sun-photometry data. To this end, aerosol light absorption coefficients at the surface are inferred from the ”columnar” aerosol aerosol light absorption coefficient records from the Rome Tor Vergata AERONET sun-photometer. The main focus of this work is to rescale aerosol light absorption columnar data (AERONET) to ground-level BC data. This is done by using values of mixing layer height (MLH) derived from ceilometer measurements and then by converting the absorption into eBC mass concentration through a mass–to–absorption conversion factor, the Mass Absorption Efficiency (MAE). The final aim is to obtain relevant data representative of the BC aerosol at the surface (i.e., in-situ)–so within the MLH– and then to infer a long-term record of “surface” equivalent black carbon mass concentration in Rome. To evaluate the accuracy of this procedure, we compared the AERONET-based results to in-situ measurements of aerosol light absorption coefficients (αabs) collected during some intensive field campaigns performed in Rome between 2010 and 2017. This analysis shows that different measurement methods, local emissions, and atmospheric conditions (MLH, residual layers) are some of the most important factors influencing differences between inferred and measured αabs. As a general result, ”inferred” and ”measured” αabs resulted to reach quite a good correlation (up to r = 0.73) after a screening procedure that excludes one of the major cause of discrepancy between AERONET inferred and in-situ measured αabs: the presence of highly absorbing aerosol layers at high altitude (e.g., dust), which frequently affects the Mediterranean site of Rome. Long-term trends of “inferred” αabs, eBC, and of the major optical variables that control aerosol’s direct radiative forcing (extinction aerosol optical depth, AODEXT, absorption aerosol optical depth, AODABS, and single scattering albedo, SSA) have been estimated. The Mann-Kendall statistical test associated with Sen’s slope was used to test the data for long-term trends. These show a negative trend for both AODEXT (−0.047/decade) and AODABS (−0.007/decade). The latter converts into a negative trend for the αabs of −5.9 Mm−1/decade and for eBC mass concentration of −0.76 μg/m3/decade. A positive trend is found for SSA (+0.014/decade), indicating that contribution of absorption to extinction is decreasing faster than that of scattering. These long-term trends are consistent with those of other air pollutant concentrations (i.e., PM2.5 and CO) in the Rome area. Despite some limitations, findings of this study fill a current lack in BC observations and may bear useful implications with regard to the improvement of our understanding of the impact of BC on air quality and climate in this Mediterranean urban region.