2 results
Search Results
Now showing 1 - 2 of 2
- ItemModelling and experimental evidence of the cathode erosion in a plasma spray torch(Bristol : IOP Publ., 2022) Baeva, M.; Benilov, M.S.; Zhu, T.; Testrich, H.; Kewitz, T.; Foest, R.The lifetime of tungsten cathodes used in plasma spray torches is limited by processes leading to a loss of cathode material. It was reported in the literature that the mechanism of their erosion is the evaporation. A model of the ionization layer of a cathode is developed to study the diffusive transport of evaporated tungsten atoms and tungsten ions produced due to ionization by electron impact in a background argon plasma. It is shown that the Stefan-Maxwell equations do not reduce to Fick law as one could expect for the transport of diluted species, which is due to significant diffusion velocities of argon ions. The ionization of tungsten atoms occurs in a distance of a few micrometers from the cathode surface and leads to a strong sink, which increases the net flux of tungsten atoms far beyond that obtained in absence of tungsten ions. This shows that the tungsten ions are driven by the electric field towards the cathode resulting in no net diffusive flux and no removal of tungsten species from the ionization layer even if convection is accounted for. A possible mechanism of removal is found by extending the model to comprise an anode. The extended model resolves the inter-electrode region and provides the plasma parameters for a current density corresponding to the value at the center of the cathode under typical arc currents of 600 A and 800 A. The presence of the anode causes a reversal of the electric field on the anode side, which pulls the ions away from the ionization layer of the cathode. The net flux of tungsten ions can be further fortified by convection. This model allows one to evaluate the loss of cathode material under realistic operating conditions in a quantitative agreement with measured values.
- ItemInfluence of dielectric thickness and electrode structure on the ion wind generation by micro fabricated plasma actuators(Bristol : IOP Publ., 2020) Hink, R.; Pipa, A.V.; Schäfer, J.; Caspari, R.; Weichwald, R.; Foest, R.; Brandenburg, R.Surface dielectric barrier discharges are investigated in order to explore the combined effects of barrier thickness and microstructure of the exposed electrode on the ion wind generation. Actuators with straight and structured high voltage electrodes with characteristic sizes of 200 and 250 µm and dielectric thicknesses of 0.5, 1 and 2 mm are compared. It is observed that: i) actuator efficiency of ion wind generation strongly depends on the applied voltage amplitude; ii) operation voltage depends on the dielectric thickness logarithmically; iii) electrode microstructure slightly increases the dynamic pressure (few percent in maximum), however the effect decreases with thicker dielectrics and smaller electrode structures; iv) the pattern of the most intensive discharge parts as well as the dielectric erosion repeats the regular structure of the electrodes down to 200 µm. Several identical samples are tested during different days to estimate the impact of the air humidity and the degradation of the dielectric. The microscale precision of the sample manufacture was accomplished by a commercial facility for printed circuit boards. © 2020 The Author(s). Published by IOP Publishing Ltd.