6 results
Search Results
Now showing 1 - 6 of 6
- ItemSporadic Ca and Ca+ layers at mid-latitudes: Simultaneous observations and implications for their formation(München : European Geopyhsical Union, 2001) Gerding, M.; Alpers, M.; Höffner, J.; von Zahn, U.We report on the observations of 188 sporadic layers of either Ca atoms and/or Ca ions that we have observed during 112 nights of lidar soundings of Ca, and 58 nights of Ca+ soundings, at Kühlungsborn, Germany (54° N, 12° E). The Ca+ soundings have been performed simultaneously and in a common volume with the Ca soundings by two separate lidars. Correlations between sporadic neutral and ionized metal layers are demonstrated through four case studies. A systematic study of the variations of occurrence of sporadic Ca and Ca+ layers reveals that neutral and ionized Ca layers are not as closely correlated as expected earlier: (a) The altitude distribution shows the simultaneous occurrence of both sporadic Ca and Ca+ layers to be most likely only in the narrow altitude range between 90 and 95 km. Above that region, in the lower thermosphere, the sporadic ion layers are much more frequent than atom layers. Below 90 km only very few sporadic layers have been observed; (b) The seasonal variation of sporadic Ca layers exhibits a minimum of occurrence in summer, while sporadic Ca+ layers do not show a significant seasonal variation (only the dense Ca+ layers appear to have a maximum in summer). At mid-latitudes sporadic Ca layers are more frequent than sporadic layers of other atmospheric metals like Na or K. For the explanation of our observations new formation mechanisms are discussed.
- ItemSeasonal variation of nocturnal temperatures between 1 and 105 km altitude at 54° N observed by lidar(München : European Geopyhsical Union, 2008) Gerding, M.; Höffner, J.; Lautenbach, J.; Rauthe, M.; Lübken, F.-J.Temperature soundings are performed by lidar at the mid-latitude station of Kühlungsborn (Germany, 54° N, 12° E). The profiles cover the complete range from the lower troposphere (~1 km) to the lower thermosphere (~105 km) by simultaneous and co-located operation of a Rayleigh-Mie-Raman lidar and a potassium resonance lidar. Observations have been done during 266 nights between June 2002 and July 2007, each of 3–15 h length. This large and unique data set provides comprehensive information on the altitudinal and seasonal variation of temperatures from the troposphere to the lower thermosphere. The remaining day-to-day-variability is strongly reduced by harmonic fits at constant altitude levels and a representative data set is achieved. This data set reveals a two-level mesopause structure with an altitude of about 86–87 km (~144 K) in summer and ~102 km (~170 K) during the rest of the year. The average stratopause altitude is ~48 km throughout the whole year, with temperatures varying between 258 and 276 K. From the fit parameters amplitudes and phases of annual, semi-annual, and quarter-annual variations are derived. The amplitude of the annual component is largest with amplitudes of up to 30 K in 85 km, while the quarter-annual variation is smallest and less than 3 K at all altitudes. The lidar data set is compared with ECMWF temperatures below about 70 km altitude and reference data from the NRLMSISE-00 model above. Apart from the temperature soundings the aerosol backscatter ratio is measured between 20 and 35 km. The seasonal variation of these values is presented here for the first time.
- ItemThe thermal structure at the topside and above of polar mesosphere summer echoes over Spitsbergen 78° N(München : European Geopyhsical Union, 2008) Lautenbach, J.; Höffner, J.; Lübken, F.-J.; Zecha, M.Simultaneous measurements of temperature and polar mesosphere summer echoes (PMSE) were performed at the polar cap (78° N) during summer 2001 and 2003. In summer time the mesopause region is characterized by extremely low temperatures around 120 K. It is remarkable that PMSE are practically never observed above 92 km although temperatures are low enough to allow the existence of ice particles. In this case study we compare the PMSE topside with temperatures measured by the potassium lidar and with frost point temperatures using water-vapor mixing ratios from models. We find striking discrepancies with our current understanding of ice particles and temperature in this region. In this case study we find that the temperature can be more than 20 K lower than the frost point temperature but no PMSE is observed above 92 km altitude. We show that the lack of PMSE does not necessarily imply that the temperature is too high.
- ItemFirst observations of noctilucent clouds by lidar at Svalbard, 78° N(München : European Geopyhsical Union, 2003) Höffner, J.; Fricke-Begemann, C.; Lübken, F.-J.In summer 2001 a potassium lidar was installed near Longyearbyen (78° N) on the north polar island of Spitsbergen which is part of the archipelago Svalbard. At the same place a series of meteorological rockets ("falling spheres", FS) were launched which gave temperatures from the lower thermosphere to the stratosphere. The potassium lidar is capable of detecting noctilucent clouds (NLCs) and of measuring temperatures in the lower thermosphere, both under daylight conditions. In this paper we give an overview on the NLC measurements (the first at this latitude) and compare the results with temperatures from meteorological rockets which have been published recently (Lübken and Mülleman, 2003) NLCs were observed from 12 June (the first day of operation) until 12 August when a period of bad weather started. When the lidar was switched on again on 26 August, no NLC was observed. The mean occurrence frequency in the period 12 June -- 12 August ("lidar NLC period") is 77%. The mean of all individual NLC peak altitudes is 83.6 km (variability: 1.1 km). The mean peak NLC altitude does not show a significant variation with season. The average top and bottom altitude of the NLC layer is 85.1 and 82.5 km, respectively, with a variability of ~1.2 km. The mean of the maximum volume backscatter coefficient bmax at our wavelength of 770 nm is 3.9 x 10-10/m/sr with a large variability of ±3.8 x 10-10/m/sr. Comparison of NLC characteristics with measurements at ALOMAR (69° N) shows that the peak altitude and the maximum volume backscatter coefficient are similar at both locations but NLCs occur more frequently at higher latitudes. Simultaneous temperature and NLC measurements are available for 3 flights and show that the NLC layer occurs in the lower part of the height range with super-saturation. The NLC peak occurs over a large range of degree of saturation (S) whereas most models predict the peak at S = 1. This demonstrates that steady-state considerations may not be applicable when relating individual NLC properties to background conditions. On the other hand, the mean variation of the NLC appearance with height and season is in agreement with the climatological variation of super-saturation derived from the FS temperature measurements.
- ItemTemperature lidar measurements from 1 to 105 km altitude using resonance, Rayleigh, and Rotational Raman scattering(München : European Geopyhsical Union, 2004) Alpers, M.; Eixmann, R.; Fricke-Begemann, C.; Gerding, M.; Höffner, J.For the first time, three different temperature lidar methods are combined to obtain time-resolved complete temperature profiles with high altitude resolution over an altitude range from the planetary boundary layer up to the lower thermosphere (about 1–105 km). The Leibniz-Institute of Atmospheric Physics (IAP) at Kühlungsborn, Germany (54° N, 12° E) operates two lidar instruments, using three different temperature measurement methods, optimized for three altitude ranges: (1) Probing the spectral Doppler broadening of the potassium D1 resonance lines with a tunable narrow-band laser allows atmospheric temperature profiles to be determined at metal layer altitudes (80–105 km). (2) Between about 20 and 90 km, temperatures were calculated from Rayleigh backscattering by air molecules, where the upper start values for the calculation algorithm were taken from the potassium lidar results. Correction methods have been applied to account for, e.g. Rayleigh extinction or Mie scattering of aerosols below about 32 km. (3) At altitudes below about 25 km, backscattering in the Rotational Raman lines is strong enough to obtain temperatures by measuring the temperature dependent spectral shape of the Rotational Raman spectrum. This method works well down to about 1 km. The instrumental configurations of the IAP lidars were optimized for a 3–6 km overlap of the temperature profiles at the method transition altitudes. We present two night-long measurements with clear wave structures propagating from the lower stratosphere up to the lower thermosphere.
- ItemThe mesospheric metal layer topside: A possible connection to meteoroids(München : European Geopyhsical Union, 2004) Höffner, J.; Friedman, J.S.In the past, many studies have been carried out to demonstrate the influence of meteoroids on the atmospheric metal layer, observed roughly in the altitude range 80–105 km. Even with the capability of present day resonance lidars to measure metal densities within single meteor trails, it has been difficult to prove any influence of meteors on the average metal layer. In contrast to approaches taken earlier, we discuss here the seasonal characteristics of potassium, calcium, calcium ion, iron and sodium above 110 km altitude where the average nocturnal densities are so low that the existence of a baseline level of metal atoms and ions is often overlooked. By comparing simultaneous and common-volume observations of different metal layers at one location, we demonstrate that despite their different seasonal characteristics at lower altitudes remarkably similar seasonal characteristics are observed at higher altitudes. In addition, a qualitative agreement is also found for potassium at different latitudes. A comparison of metal densities at 113 km altitude with known meteor showers indicates a strong influence of shower meteoroids on the topside of the metal layers. Simultaneous observations of K along with Ca, Fe and/or Na permit the calculation of abundance ratios, which at 113 km altitude are quite similar to values measured in single meteor trails by ground based lidars. Furthermore, the increase in densities throughout summer is strong evidence for the influence of sporadic meteoroids on the high metal layers. This increase correlates well with the seasonal variation of sporadic micrometeor input independent of meteor showers. Given these evidences, we contend that there is a direct influence of ablating meteoroids on the topside of the mesospheric metal layer.