5 results
Search Results
Now showing 1 - 5 of 5
- Item60% Efficient Monolithically Wavelength-Stabilized 970-nm DBR Broad-Area Lasers(New York, NY : IEEE, 2022) Crump, Paul; Miah, M. Jarez; Wilkens, Martin; Fricke, Jorg; Wenzel, Hans; Knigge, AndreaProgress in epitaxial design is shown to enable increased optical output power P opt and power conversion efficiency η E and decreased lateral far-field divergence angle in GaAs-based distributed Bragg reflector (DBR) broad-area (BA) diode lasers. We show that the wavelength-locked power can be significantly increased (saturation at high bias current is mitigated) by migrating from an asymmetric large optical cavity (ASLOC) based laser structure to a highly asymmetric (extreme-triple-asymmetric (ETAS)) layer design. For wavelength-stabilization, 7 th order, monolithic DBRs are etched on the surface of fully grown epitaxial layer structures. The investigated ETAS reference Fabry-Pérot (FP) BA lasers without DBRs and with 200 µm stripe width and 4 mm cavity length provide P opt = 29 W (still increasing) at 30 A in continuous-wave mode at room temperature, in contrast to the maximum P opt = 24 W (limited by strong power saturation) of baseline ASLOC lasers. The reference ETAS FP lasers also deliver over 10% higher η E at P opt = 24 W. On the other hand, in comparison to the wavelength-stabilized ASLOC DBR lasers, ETAS DBR lasers show a peak power increment from 14 W to 22 W, and an efficiency increment from 46% to 60% at P opt = 14 W. A narrow spectral width (< 1 nm at 95% power content) is maintained across a very wide operating range. Consistent with earlier studies, a narrower far-field divergence angle and consequently an improved beam-parameter product is also observed, compared to the ASLOC-based lasers.
- ItemVersatile high power pulse-laser source for pico- and nanosecond optical pulses(London : Institute of Physics, 2020) Liero, Armin; Klehr, Andreas; Knigge, Andrea; Heinrich, WolfgangThis paper presents a pulse-laser source for the generation of ps and ns laser pulses with more than 50 W peak output power. The final stages of the drivers use GaN transistors and are capable of switching currents of 0.8 A with 200 ps minimum pulse width and 50 A with 3 ns minimum pulse width. The pulses can be externally triggered by ECL logic. Both single-pulse and pulse train modes are possible.
- ItemWavelength-stabilized ns-pulsed 2.2 kW diode laser bar with multiple active regions and tunnel junctions(Stevenage : IET, 2022) Ammouri, Nor; Christopher, Heike; Fricke, Jörg; Ginolas, Arnim; Liero, Armin; Maaßdorf, Andre; Wenzel, Hans; Knigge, AndreaThe improvement of the performance of a distributed Bragg reflector laser bar emitting near 905 nm through the use of multiple epitaxially stacked active regions and tunnel junctions is reported. The bar consisting of 48 emitters (each having an aperture of 50 µm) emits an optical power of 2.2 kW in 8 ns long pulses at an injection current of 1.1 kA. This corresponds to an almost threefold increase of the pulse power compared to a bar with lasers having only a single active region. Due to the integrated surface Bragg grating, the bar exhibits a narrow spectral bandwidth of about 0.3 nm and a thermal tuning of only 68 pm/K.
- ItemStability of ZnSe-Passivated Laser Facets Cleaved in Air and in Ultra-High Vacuum(New York, NY : IEEE, 2022) Boschker, Jos E.; Spengler, Uwe; Ressel, Peter; Schmidbauer, Martin; Mogilatenko, Anna; Knigge, AndreaCatastrophic optical mirror damage (COMD) is one of the main failure mechanisms limiting the reliability of GaAs based laser diodes. Here, we compare the facet stability of ZnSe-passivated ridge-waveguide lasers (RWLs) that are cleaved in air and subsequently cleaned using atomic hydrogen with RWLs that are cleaved in ultra-high vacuum. RWLs cleaved in ultra-high vacuum show a superior performance and reach power densities up to 58 MW/cm 2 under extended continuous wave operation at 1064 nm. This is attributed to the reduction of defects at the interface between ZnSe and the cleaved facet as evidenced by transmission electron microscopy and X-ray diffraction.
- ItemSimulation and analysis of high-brightness tapered ridge-waveguide lasers(Dordrecht [u.a.] : Springer Science + Business Media B.V, 2023) Koester, Jan-Philipp; Wenzel, Hans; Wilkens, Martin; Knigge, AndreaIn this work, a simulation-based analysis of a CW-driven tapered ridge-waveguide laser design is presented. Measurements of these devices delivered high lateral brightness values of 4 W · mm - 1mrad - 1 at 2.5W optical output power. First, active laser simulations are performed to reproduce these results. Next, the resulting complex valued intra-cavity refractive index distributions are the basis for a modal and beam propagation analysis, which demonstrates the working principle and limitation of the underlying lateral mode filter effect. Finally, the gained understanding is the foundation for further design improvements leading to lateral brightness values of up to 10 W · mm - 1mrad - 1 predicted by simulations.