9 results
Search Results
Now showing 1 - 9 of 9
- ItemEnhanced thermal stability of yttrium oxide-based RRAM devices with inhomogeneous Schottky-barrier(Melville, NY : American Inst. of Physics, 2020) Piros, Eszter; Petzold, Stefan; Zintler, Alexander; Kaiser, Nico; Vogel, Tobias; Eilhardt, Robert; Wenger, Christian; Molina-Luna, Leopoldo; Alff, LambertThis work addresses the thermal stability of bipolar resistive switching in yttrium oxide-based resistive random access memory revealed through the temperature dependence of the DC switching behavior. The operation voltages, current levels, and charge transport mechanisms are investigated at 25 °C, 85 °C, and 125 °C, and show overall good temperature immunity. The set and reset voltages, as well as the device resistance in both the high and low resistive states, are found to scale inversely with increasing temperatures. The Schottky-barrier height was observed to increase from approximately 1.02 eV at 25 °C to approximately 1.35 eV at 125 °C, an uncommon behavior explained by interface phenomena. © 2020 Author(s).
- ItemOperando diagnostic detection of interfacial oxygen ‘breathing’ of resistive random access memory by bulk-sensitive hard X-ray photoelectron spectroscopy(London [u.a.] : Taylor & Francis, 2019) Niu, Gang; Calka, Pauline; Huang, Peng; Sharath, Sankaramangalam Ulhas; Petzold, Stefan; Gloskovskii, Andrei; Fröhlich, Karol; Zhao, Yudi; Kan, Jinfeng; Schubert, Markus Andreas; Bärwolf, Florian; Ren, Wei; Ye, Zuo-Guang; Perez, Eduardo; Wenger, Christian; Alff, Lambert; Schroeder, ThomasThe HfO2-based resistive random access memory (RRAM) is one of the most promising candidates for non-volatile memory applications. The detection and examination of the dynamic behavior of oxygen ions/vacancies are crucial to deeply understand the microscopic physical nature of the resistive switching (RS) behavior. By using synchrotron radiation based, non-destructive and bulk-sensitive hard X-ray photoelectron spectroscopy (HAXPES), we demonstrate an operando diagnostic detection of the oxygen ‘breathing’ behavior at the oxide/metal interface, namely, oxygen migration between HfO2 and TiN during different RS periods. The results highlight the significance of oxide/metal interfaces in RRAM, even in filament-type devices. IMPACT STATEMENT: The oxygen ‘breathing’ behavior at the oxide/metal interface of filament-type resistive random access memory devices is operandoly detected using hard X-ray photoelectron spectroscopy as a diagnostic tool. © 2019, © 2019 The Author(s). Published by Informa UK Limited, trading as Taylor & Francis Group.
- ItemCorrection: Interface-engineered reliable HfO2-based RRAM for synaptic simulation (Journal of Materials Chemistry C (2019) DOI: 10.1039/c9tc04880d)(London [u.a.] : RSC, 2019) Wang, Qiang; Niu, Gang; Roy, Sourav; Wang, Yankun; Zhang, Yijun; Wu, Heping; Zhai, Shijie; Bai, Wei; Shi, Peng; Song, Sannian; Song, Zhitang; Xie, Ya-Hong; Ye, Zuo-Guang; Wenger, Christian; Meng, Xiangjian; Ren, WeiThere was an error in the author list of this published article. The corresponding authors for this paper are Gang Niu (gangniu@xjtu.edu.cn) and Wei Ren (wren@mail.xjtu.edu.cn). The footnote indicating that Qiang Wang and Gang Niu contributed equally to the work was not intended. The corrected author list and notations are shown here. The Royal Society of Chemistry apologises for these errors and any consequent inconvenience to authors and readers. © The Royal Society of Chemistry 2019.
- ItemOptimization of Multi-Level Operation in RRAM Arrays for In-Memory Computing(Basel : MDPI, 2021) Pérez, Eduardo; Pérez-Ávila, Antonio Javier; Romero-Zaliz, Rocío; Mahadevaiah, Mamathamba Kalishettyhalli; Pérez-Bosch Quesada, Emilio; Roldán, Juan Bautista; Jiménez-Molinos, Francisco; Wenger, ChristianAccomplishing multi-level programming in resistive random access memory (RRAM) arrays with truly discrete and linearly spaced conductive levels is crucial in order to implement synaptic weights in hardware-based neuromorphic systems. In this paper, we implemented this feature on 4-kbit 1T1R RRAM arrays by tuning the programming parameters of the multi-level incremental step pulse with verify algorithm (M-ISPVA). The optimized set of parameters was assessed by comparing its results with a non-optimized one. The optimized set of parameters proved to be an effective way to define non-overlapped conductive levels due to the strong reduction of the device-to-device variability as well as of the cycle-to-cycle variability, assessed by inter-levels switching tests and during 1 k reset-set cycles. In order to evaluate this improvement in real scenarios, the experimental characteristics of the RRAM devices were captured by means of a behavioral model, which was used to simulate two different neuromorphic systems: an 8 × 8 vector-matrix-multiplication (VMM) accelerator and a 4-layer feedforward neural network for MNIST database recognition. The results clearly showed that the optimization of the programming parameters improved both the precision of VMM results as well as the recognition accuracy of the neural network in about 6% compared with the use of non-optimized parameters.
- ItemProgramming Pulse Width Assessment for Reliable and Low-Energy Endurance Performance in Al:HfO2-Based RRAM Arrays(Basel : MDPI AG, 2020) Pérez, Eduardo; Ossorio, Óscar González; Dueñas, Salvador; Castán, Helena; García, Héctor; Wenger, ChristianA crucial step in order to achieve fast and low-energy switching operations in resistive random access memory (RRAM) memories is the reduction of the programming pulse width. In this study, the incremental step pulse with verify algorithm (ISPVA) was implemented by using different pulse widths between 10 μ s and 50 ns and assessed on Al-doped HfO 2 4 kbit RRAM memory arrays. The switching stability was assessed by means of an endurance test of 1k cycles. Both conductive levels and voltages needed for switching showed a remarkable good behavior along 1k reset/set cycles regardless the programming pulse width implemented. Nevertheless, the distributions of voltages as well as the amount of energy required to carry out the switching operations were definitely affected by the value of the pulse width. In addition, the data retention was evaluated after the endurance analysis by annealing the RRAM devices at 150 °C along 100 h. Just an almost negligible increase on the rate of degradation of about 1 μ A at the end of the 100 h of annealing was reported between those samples programmed by employing a pulse width of 10 μ s and those employing 50 ns. Finally, an endurance performance of 200k cycles without any degradation was achieved on 128 RRAM devices by using programming pulses of 100 ns width.
- ItemControl of etch pit formation for epitaxial growth of graphene on germanium(Melville, NY : American Inst. of Physics, 2019) Becker, Andreas; Wenger, Christian; Dabrowski, JarekGraphene epitaxy on germanium by chemical vapor deposition is a promising approach to integrate graphene into microelectronics, but the synthesis is still accompanied by several challenges such as the high process temperature, the reproducibility of growth, and the formation of etch pits during the process. We show that the substrate cleaning by preannealing in molecular hydrogen, which is crucial to successful and reproducible graphene growth, requires a high temperature and dose. During both substrate cleaning and graphene growth, etch pits can develop under certain conditions and disrupt the synthesis process. We explain the mechanisms how these etch pits may form by preferential evaporation of substrate, how substrate topography is related to the state of the cleaning process, and how etch pit formation during graphene growth can be controlled by choice of a sufficiently high precursor flow. Our study explains how graphene can be grown reliably on germanium at high temperature and thereby lays the foundation for further optimization of the growth process. © 2019 Author(s).
- ItemModulating the Filamentary-Based Resistive Switching Properties of HfO2 Memristive Devices by Adding Al2O3 Layers(Basel : MDPI, 2022) Kalishettyhalli Mahadevaiah, Mamathamba; Perez, Eduardo; Lisker, Marco; Schubert, Markus Andreas; Perez-Bosch Quesada, Emilio; Wenger, Christian; Mai, AndreasThe resistive switching properties of HfO2 based 1T-1R memristive devices are electrically modified by adding ultra-thin layers of Al2 O3 into the memristive device. Three different types of memristive stacks are fabricated in the 130 nm CMOS technology of IHP. The switching properties of the memristive devices are discussed with respect to forming voltages, low resistance state and high resistance state characteristics and their variabilities. The experimental I–V characteristics of set and reset operations are evaluated by using the quantum point contact model. The properties of the conduction filament in the on and off states of the memristive devices are discussed with respect to the model parameters obtained from the QPC fit.
- ItemToward Reliable Compact Modeling of Multilevel 1T-1R RRAM Devices for Neuromorphic Systems(Basel : MDPI AG, 2021) Perez-Bosch Quesada, Emilio; Romero-Zaliz, Rocio; Perez, Eduardo; Kalishettyhalli Mahadevaiah, Mamathamba; Reuben, John; Schubert, Markus Andreas; Jimenez-Molinos, Francisco; Roldan, Juan Bautista; Wenger, ChristianIn this work, three different RRAM compact models implemented in Verilog-A are analyzed and evaluated in order to reproduce the multilevel approach based on the switching capability of experimental devices. These models are integrated in 1T-1R cells to control their analog behavior by means of the compliance current imposed by the NMOS select transistor. Four different resistance levels are simulated and assessed with experimental verification to account for their multilevel capability. Further, an Artificial Neural Network study is carried out to evaluate in a real scenario the viability of the multilevel approach under study.
- ItemRole of Oxygen Defects in Conductive-Filament Formation in Y2O3-Based Analog RRAM Devices as Revealed by Fluctuation Spectroscopy(College Park, Md. [u.a.] : American Physical Society, 2020) Piros, Eszter; Lonsky, Martin; Petzold, Stefan; Zintler, Alexander; Sharath, S.U.; Vogel, Tobias; Kaiser, Nico; Eilhardt, Robert; Molina-Luna, Leopoldo; Wenger, Christian; Müller, Jens; Alff, LambertLow-frequency noise in Y2O3-based resistive random-access memory devices with analog switching is studied at intermediate resistive states and as a function of dc cycling. A universal 1/fα-type behavior is found, with a frequency exponent of α≈1.2 that is independent of the applied reset voltage or the device resistance and is attributed to the intrinsic abundance of oxygen vacancies unique to the structure of yttria. Remarkably, the noise magnitude in the high resistive state systematically decreases through dc training. This effect is attributed to the stabilization of the conductive filament via the consumption of oxygen vacancies, thus reducing the number of active fluctuators in the vicinity of the filament.