7 results
Search Results
Now showing 1 - 7 of 7
- ItemSpatially modulated broad-area lasers for narrow lateral far-field divergence(Washington, DC : Soc., 2021) Zeghuzi, Anissa; Koester, Jan-Philipp; Radziunas, Mindaugas; Christopher, Heike; Wenzel, Hans; Knigge, AndreaA novel laser design is presented that combines a longitudinal-lateral gain-loss modulation with an additional phase tailoring achieved by etching rectangular trenches. At 100 A pulsed operation, simulations predict a far-field profile with 0.3° full width at half maximum (ΘFWHM=0.3∘) where a 0.4°-wide main lobe contains 40% of the emitted optical output power (Θ40%=0.4∘). While far-field measurements of these structured lasers emitting 10 ns long pulses with 35 W peak power confirm a substantial enhancement of radiation within the central 1∘ angular range, the measured far-field intensity outside of the obtained central peak remains high.
- Item16.3 w peak‐power pulsed all‐diode laser based multi‐wavelength master‐oscillator power‐amplifier system at 964 nm(Basel : MDPI, 2021) Vu, Thi Nghiem; Tien, Tran Quoc; Sumpf, Bernd; Klehr, Andreas; Fricke, Jörg; Wenzel, Hans; Tränkle, GüntherAn all-diode laser-based master oscillator power amplifier (MOPA) configuration for the generation of ns-pulses with high peak power, stable wavelength and small spectral line width is presented. The MOPA emits alternating at two wavelengths in the spectral range between 964 nm and 968 nm, suitable for the detection of water vapor by absorption spectroscopy. The monolithic master oscillator (MO) consists of two slightly detuned distributed feedback laser branches, whose emission is combined in a Y-coupler. The two emission wavelengths can be adjusted by varying the current or temperature to an absorption line and to a non-absorbing region. The power amplifier (PA) consists of a ridge-waveguide (RW) section and a tapered section, monolithically integrated within one chip. The RW section of the PA acts as an optical gate and converts the continuous wave input beam emitted by the MO into a sequence of short optical pulses, which are subsequently amplified by the tapered section to boost the output power. For a pulse width of 8 ns, a peak power of 16.3 W and a side mode suppression ratio of more than 37 dB are achieved at a repetition rate of 25 kHz. The measured spectral width of 10 pm, i.e., 0.1 cm−1, is limited by the resolution of the optical spectrum analyzer. The generated pulses emitting alternating at two wavelengths can be utilized in a differential absorption light detection and ranging system.
- ItemWavelength-stabilized ns-pulsed 2.2 kW diode laser bar with multiple active regions and tunnel junctions(Stevenage : IET, 2022) Ammouri, Nor; Christopher, Heike; Fricke, Jörg; Ginolas, Arnim; Liero, Armin; Maaßdorf, Andre; Wenzel, Hans; Knigge, AndreaThe improvement of the performance of a distributed Bragg reflector laser bar emitting near 905 nm through the use of multiple epitaxially stacked active regions and tunnel junctions is reported. The bar consisting of 48 emitters (each having an aperture of 50 µm) emits an optical power of 2.2 kW in 8 ns long pulses at an injection current of 1.1 kA. This corresponds to an almost threefold increase of the pulse power compared to a bar with lasers having only a single active region. Due to the integrated surface Bragg grating, the bar exhibits a narrow spectral bandwidth of about 0.3 nm and a thermal tuning of only 68 pm/K.
- Item60% Efficient Monolithically Wavelength-Stabilized 970-nm DBR Broad-Area Lasers(New York, NY : IEEE, 2022) Crump, Paul; Miah, M. Jarez; Wilkens, Martin; Fricke, Jorg; Wenzel, Hans; Knigge, AndreaProgress in epitaxial design is shown to enable increased optical output power P opt and power conversion efficiency η E and decreased lateral far-field divergence angle in GaAs-based distributed Bragg reflector (DBR) broad-area (BA) diode lasers. We show that the wavelength-locked power can be significantly increased (saturation at high bias current is mitigated) by migrating from an asymmetric large optical cavity (ASLOC) based laser structure to a highly asymmetric (extreme-triple-asymmetric (ETAS)) layer design. For wavelength-stabilization, 7 th order, monolithic DBRs are etched on the surface of fully grown epitaxial layer structures. The investigated ETAS reference Fabry-Pérot (FP) BA lasers without DBRs and with 200 µm stripe width and 4 mm cavity length provide P opt = 29 W (still increasing) at 30 A in continuous-wave mode at room temperature, in contrast to the maximum P opt = 24 W (limited by strong power saturation) of baseline ASLOC lasers. The reference ETAS FP lasers also deliver over 10% higher η E at P opt = 24 W. On the other hand, in comparison to the wavelength-stabilized ASLOC DBR lasers, ETAS DBR lasers show a peak power increment from 14 W to 22 W, and an efficiency increment from 46% to 60% at P opt = 14 W. A narrow spectral width (< 1 nm at 95% power content) is maintained across a very wide operating range. Consistent with earlier studies, a narrower far-field divergence angle and consequently an improved beam-parameter product is also observed, compared to the ASLOC-based lasers.
- ItemSimulation and analysis of high-brightness tapered ridge-waveguide lasers(Dordrecht [u.a.] : Springer Science + Business Media B.V, 2023) Koester, Jan-Philipp; Wenzel, Hans; Wilkens, Martin; Knigge, AndreaIn this work, a simulation-based analysis of a CW-driven tapered ridge-waveguide laser design is presented. Measurements of these devices delivered high lateral brightness values of 4 W · mm - 1mrad - 1 at 2.5W optical output power. First, active laser simulations are performed to reproduce these results. Next, the resulting complex valued intra-cavity refractive index distributions are the basis for a modal and beam propagation analysis, which demonstrates the working principle and limitation of the underlying lateral mode filter effect. Finally, the gained understanding is the foundation for further design improvements leading to lateral brightness values of up to 10 W · mm - 1mrad - 1 predicted by simulations.
- ItemHybrid integrated mode-locked laser using a GaAs-based 1064 nm gain chip and a SiN external cavity(Washington, DC : Soc., 2022) Vissers, Ewoud; Poelman, Stijn; Wenzel, Hans; Christopher, Heike; Van Gasse, Kasper; Knigge, Andrea; Kuyken, BartExternal cavity mode-locked lasers could be used as comb sources for high volume application such as LIDAR and dual comb spectroscopy. Currently demonstrated chip scale integrated mode-locked lasers all operate in the C-band. In this paper, a hybrid-integrated external cavity mode-locked laser working at 1064 nm is demonstrated, a wavelength beneficial for optical coherence tomography or Raman spectroscopy applications. Additionally, optical injection locking is demonstrated, showing an improvement in the optical linewidth, and an increased stability of the comb spectrum.
- ItemWavelength stabilized high pulse power 48 emitter laser bars for automotive light detection and ranging application(Bristol : IOP Publ., 2020) Klehr, Andreas; Liero, Armin; Christopher, Heike; Wenzel, Hans; Maaßdorf, Andre; Della Casa, Pietro; Fricke, Jörg; Ginolas, Arnim; Knigge, AndreaDiode lasers generating optical pulses with high peak power and lengths in the nanosecond range are key components for light detection and ranging systems, e.g. for autonomous driving and object detection. We present here an internally wavelength stabilized distributed Bragg reflector broad area laser bar with 48 emitters. The vertical structure based on AlGaAs (confinement and cladding layers) and InGaAs (active quantum well) is specifically optimized for wavelength-stabilized pulsed operation, applying a surface Bragg grating with high reflectivity. The bar is electrically driven by a new in-house developed high-speed driver based on GaN transistors providing current pulses with amplitudes of up to 1000 A and a repetition frequency of 10 kHz. The generated 4 ns to 10 ns long optical pulses are nearly rectangular shaped and reach a pulse peak power in excess of 600 Watts at 25 °C. The optical spectrum with a centre wavelength of about 900 nm has a width of 0.15 nm (FWHM) with a side mode suppression ratio > 30 dB. © 2020 IOP Publishing Ltd.