Filters

20192

More filters

2020 - 20212
Reset filters

Settings

End date: 2021 × Start date: 2020 × End date: 2019 × Start date: 2019 × Has files: Yes × Publisher: Basel : MDPI AG × Subject: Antennas ×

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Electroless-deposited platinum antennas for wireless surface acousticwave sensors
    (Basel : MDPI AG, 2019) Brachmann, E.; Seifert, M.; Neumann, N.; Alshwawreh, N.; Uhlemann, M.; Menzel, S.B.; Acker, J.; Herold, S.; Hoffmann, V.; Gemming, T.
    In an effort to develop a cost-efficient technology for wireless high-temperature surface acoustic wave sensors, this study presents an evaluation of a combined method that integrates physical vapor deposition with electroless deposition for the fabrication of platinum-based planar antennas. The proposed manufacturing process becomes attractive for narrow, thick, and sparse metallizations for antennas in the MHz to GHz frequency range. In detail, narrow platinum-based lines of a width down to 40 μm were electroless-deposited on γ -Al2O3 substrates using different seed layers. At first, the electrolyte chemistry was optimized to obtain the highest deposition rate. Films with various thickness were prepared and the electrical resistivity, microstructure, and chemical composition in the as-prepared state and after annealing at temperatures up to 1100 °C were evaluated. Using these material parameters, the antenna was simulated with an electromagnetic full-wave simulation tool and then fabricated. The electrical parameters, including the S-parameters of the antenna, were measured. The agreement between the simulated and the realized antenna is then discussed.
  • Thumbnail Image
    Item
    Compact differential-fed planar filtering antennas
    (Basel : MDPI AG, 2019) Hassan, Emadeldeen; Martynenko, Denys; Wadbro, Eddie; Fischer, Gunter; Berggren, Martin
    This paper proposes novel low-profile differential-fed planar antennas with embedded sharp frequency selectively. The antennas are compact and easy to integrate with differential devices without matching baluns. The antenna design is formulated as a topology optimization problem, where requirements on impedance bandwidth, directivity, and filtering are used as the design objectives. The optimized antennas operate over the frequency band 6.0-8.5 GHz. The antennas have reflection coefficients below -15 dB, cross-polarization levels below -42 dB, a maximum gain of 6.0 ± 0.5 dB, and a uniform directivity over more than 130° beamwidth angle in the frequency band of interest. In addition, the antennas exhibit sharp roll-off between the operational band and frequencies around the 5.8GHz WiFi band and the 10 GHz X-band. One antenna has been fabricated with a good match between simulation and measurement results. © 2019 by the authors. Licensee MDPI, Basel, Switzerland.