5 results
Search Results
Now showing 1 - 5 of 5
- ItemRaman imaging to study structural and chemical features of the dentin enamel junction(London [u.a.] : Institute of Physics, 2015) Alebrahim, M.A.; Krafft, C.; Popp, J.; El-Khateeb, Mohammad Y.The structure and chemical features of the human dentin enamel junction (DEJ) were characterized using Raman spectroscopic imaging. Slices were prepared from 10 German, and 10 Turkish teeth. Raman images were collected at 785 nm excitation and the average Raman spectra were calculated for analysis. Univariate and multivariate spectral analysis were applied for investigation. Raman images were obtained based on the intensity ratios of CH at 1450 cm-1 (matrix) to phosphate at 960 cm-1 (mineral), and carbonate to phosphate (1070/960) ratios. Different algorithms (HCA, K-means cluster and VCA) also used to study the DEJ. The obtained results showed that the width of DEJ is about 5 pm related to univariate method while it varies from 6 to 12 μm based on multivariate spectral technique. Both spectral analyses showed increasing in carbonate content inside the DEJ compared to the dentin, and the amide I (collagen) peak in dentin spectra is higher than DEJ spectra peak.
- ItemCarrier Lifetime in Liquid-phase Crystallized Silicon on Glass(Amsterdam [u.a.] : Elsevier, 2016) Vetter, Michael; Gawlik, Annett; Plentz, Jonathan; Andrä, Gudrun; Ribeyron, Pierre-Jean; Cuevas, Andres; Weeber, Arthur; Ballif, Christophe; Glunz, Stefan; Poortmans, Jef; Brendel, Rolf; Aberle, Armin; Sinton, Ron; Verlinden, Pierre; Hahn, GisoLiquid-phase crystallized silicon on glass (LPCSG) presents a promising material to fabricate high quality silicon thin films, e.g. for solar cells and modules. Barrier layers and a doped amorphous silicon layer are deposited on the glass substrate followed by crystallization with a line focus laser beam. In this paper we introduce injection level dependent lifetime measurements generated by the quasi steady-state photoconductance decay method (QSSPC) to characterize LPCSG absorbers. This contactless method allows a determination of the LPCSG absorber quality already at an early stage of solar cell fabrication, and provides a monitoring of the absorber quality during the solar cell fabrication steps. We found minority carrier lifetimes higher than 200ns in our layers (e.g. n-type absorber with ND=2x1015cm-3) indicating a surface recombination velocity SBL<3000cm/s at the barrier layer/Si interface.
- ItemStructure and superconducting characteristics of magnesium diboride, substitution of boron atoms by oxygen and carbon(London [u.a.] : Institute of Physics, 2017) Prikhna, Tetiana; Romaka, Vitaliy; Eisterer, Michael; Shapovalov, Andrii; Kozyrev, Artem; Grechnev, Gennadiy; Boutko, Viktor; Goldacker, Wilfried; Habisreuther, Tobias; Vakaliuk, Oleksii; Halbedel, BerndAn x-ray analysis of MgB2-based materials shows that they contain MgB2 and MgO phases. According to a quantitative Auger analysis (taken after removing the oxidized surface layer by Ar ion etching in the microscope chamber) the MgB2 phase contains some amount of oxygen that approximately corresponds to the composition MgB2.2-1.7O0.4-0.6. Rietveld refinement of the MgB2 phase, based on EDX data with varying B/O content, leads to the composition MgB1.68-1.8O0.2-0.32. Ab-initio modelling of boron substitution by oxygen in MgB2 (ΔH f = -150.6 meV/atom) shows that this is energetically favourable up to the composition MgB1.75O0.25 (ΔH f = -191.4 meV/atom). In contrast to carbon substitution, where very small levels of doping can dramatically affect the superconducting characteristics of the material with concomitant changes in the electron density, oxygen substitution results in very little change in the superconducting properties of MgB2. The formation of vacancies at the Mg site of both MgB2 and substituted MgB1.75O0.25 was modelled as well, but has shown that such processes are energetically disadvantageous (ΔHf of Mg0.875B2 and Mg0.75B1.75O0.25 are equal to -45.5 and -93.5 meV/atom, respectively).
- ItemA Computational Pipeline for Sepsis Patients’ Stratification and Diagnosis([Setúbal, Portugal] : SCITEPRESS - Science and Technology Publications, Lda., 2018) Campos, David; Pinho, Renato; Neugebauer, Ute; Popp, Juergen; Oliveira, José Luis; Zwiggelaar, Reyer; Gamboa, Hugo; Fred, Ana; Bermúdez i Badia, SergiSepsis is still a little acknowledged public health issue, despite its increasing incidence and the growing mortality rate. In addition, a clear diagnosis can be lengthy and complicated, due to highly variable symptoms and non-specific criteria, causing the disease to be diagnosed and treated too late. This paper presents the HemoSpec platform, a decision support system which, by collecting and automatically processing data from several acquisition devices, can help in the early diagnosis of sepsis.
- ItemFrequency dependence of magnetothermal properties for magnetic fluid and magnetically functionalized implants(Les Ulis : EDP Sciences, 2018) Salakhova, R.T.; Vylegzhanin, A. G.; Kashtanov, E.A.; Zverev, V.I.; Müller, R.; de Sena Pereira, F.D.; Parfenov, V.A.; Mironov, V.A.; Kritskaya, E.A.; Pyatakov, A.P.; Markov, V.K.; Malyshev, A.Yu; Kamilov, K.I; Tishin, A.M; Perov, N.; Semisalova, A.Heating of the magnetic nanoparticles in AC magnetic field is the effect promising for application in medicine. The mechanisms of heating in AC-magnetic field implies nontrivial dependence of the power dissipated by magnetic nanoparticles on frequency. With the use of a reconfigurable experimental setup, this frequency-dependent magnetic heating was measured on two characteristic examples: the magnetite nanoparticles conventionally used in medicine and polymer coating with micrometer sized magnetite particles. The saturation of the heating power with frequency is shown that is more pronounced for the second case of microparticles.