8 results
Search Results
Now showing 1 - 8 of 8
- ItemWavelength stabilized high pulse power 48 emitter laser bars for automotive light detection and ranging application(Bristol : IOP Publ., 2020) Klehr, Andreas; Liero, Armin; Christopher, Heike; Wenzel, Hans; Maaßdorf, Andre; Della Casa, Pietro; Fricke, Jörg; Ginolas, Arnim; Knigge, AndreaDiode lasers generating optical pulses with high peak power and lengths in the nanosecond range are key components for light detection and ranging systems, e.g. for autonomous driving and object detection. We present here an internally wavelength stabilized distributed Bragg reflector broad area laser bar with 48 emitters. The vertical structure based on AlGaAs (confinement and cladding layers) and InGaAs (active quantum well) is specifically optimized for wavelength-stabilized pulsed operation, applying a surface Bragg grating with high reflectivity. The bar is electrically driven by a new in-house developed high-speed driver based on GaN transistors providing current pulses with amplitudes of up to 1000 A and a repetition frequency of 10 kHz. The generated 4 ns to 10 ns long optical pulses are nearly rectangular shaped and reach a pulse peak power in excess of 600 Watts at 25 °C. The optical spectrum with a centre wavelength of about 900 nm has a width of 0.15 nm (FWHM) with a side mode suppression ratio > 30 dB. © 2020 IOP Publishing Ltd.
- ItemPassive Detection and Imaging of Human Body Radiation Using an Uncooled Field-Effect Transistor-Based THz Detector(Basel : MDPI, 2020) Čibiraitė-Lukenskienė, Dovilė; Ikamas, Kęstutis; Lisauskas, Tautvydas; Krozer, Viktor; Roskos, Hartmut G.; Lisauskas, AlvydasThis work presents, to our knowledge, the first completely passive imaging with human-body-emitted radiation in the lower THz frequency range using a broadband uncooled detector. The sensor consists of a Si CMOS field-effect transistor with an integrated log-spiral THz antenna. This THz sensor was measured to exhibit a rather flat responsivity over the 0.1–1.5-THz frequency range, with values√ of the optical responsivity and noise-equivalent power of around 40 mA/W and 42 pW/ Hz, respectively. These values are in good agreement with simulations which suggest an even broader flat responsivity range exceeding 2.0 THz. The successful imaging demonstrates the impressive thermal sensitivity which can be achieved with such a sensor. Recording of a 2.3 × 7.5-cm2-sized image of the fingers of a hand with a pixel size of 1 mm2 at a scanning speed of 1 mm/s leads to a signal-to-noise ratio of 2 and a noise-equivalent temperature difference of 4.4 K. This approach shows a new sensing approach with field-effect transistors as THz detectors which are usually used for active THz detection. © 2020 by the authors. Licensee MDPI, Basel, Switzerland.
- ItemStructural and luminescence imaging and characterisation of semiconductors in the scanning electron microscope(Bristol : IOP Publ., 2020) Trager-Cowan, C.; Alasmari, A.; Avis, W.; Bruckbauer, J.; Edwards, P.R.; Ferenczi, G.; Hourahine, B.; Kotzai, A.; Kraeusel, S.; Kusch, G.; Martin, R.W.; McDermott, R.; Naresh-Kumar, G.; Nouf-Allehiani, M.; Pascal, E.; Thomson, D.; Vespucci, S.; Smith, M.D.; Parbrook, P.J.; Enslin, J.; Mehnke, F.; Kuhn, C.; Wernicke, T.; Kneissl, M.; Hagedorn, S.; Knauer, A.; Walde, S.; Weyers, M.; Coulon, P.-M.; Shields, P.A.; Bai, J.; Gong, Y.; Jiu, L.; Zhang, Y.; Smith, R.M.; Wang, T.; Winkelmann, A.The scanning electron microscopy techniques of electron backscatter diffraction (EBSD), electron channelling contrast imaging (ECCI) and cathodoluminescence (CL) hyperspectral imaging provide complementary information on the structural and luminescence properties of materials rapidly and non-destructively, with a spatial resolution of tens of nanometres. EBSD provides crystal orientation, crystal phase and strain analysis, whilst ECCI is used to determine the planar distribution of extended defects over a large area of a given sample. CL reveals the influence of crystal structure, composition and strain on intrinsic luminescence and/or reveals defect-related luminescence. Dark features are also observed in CL images where carrier recombination at defects is non-radiative. The combination of these techniques is a powerful approach to clarifying the role of crystallography and extended defects on a material's light emission properties. Here we describe the EBSD, ECCI and CL techniques and illustrate their use for investigating the structural and light emitting properties of UV-emitting nitride semiconductor structures. We discuss our investigations of the type, density and distribution of defects in GaN, AlN and AlGaN thin films and also discuss the determination of the polarity of GaN nanowires. © 2020 The Author(s). Published by IOP Publishing Ltd.
- ItemIn vivo detection of changes in cutaneous carotenoids after chemotherapy using shifted excitation resonance Raman difference and fluorescence spectroscopy(Oxford [u.a.] : Wiley-Blackwell, 2020) Jung, Sora; Darvin, Maxim E.; Schleusener, Johannes; Thiede, Gisela; Lademann, Juergen; Braune, Marcel; Elban, Felia; Fuss, HaraldBackground: Various cutaneous toxicities under chemotherapy indicate a local effect of chemotherapy by secretion after systemic application. Here, changes in the fluorescence and Raman spectral properties of the stratum corneum subsequent to intravenous chemotherapy were assessed. Methods: Twenty healthy subjects and 20 cancer patients undergoing chemotherapy were included. Measurement time points in cancer patients were before the first cycle of chemotherapy (Tbase) and immediately after intravenous application of the chemotherapy (T1). Healthy subjects were measured once without any further intervention. Measurements were conducted using an individually manufactured system consisting of a handheld probe and a wavelength-tunable diode laser-based 488 nm SHG light source. Hereby, changes in both skin fluorescence and shifted excitation resonance Raman difference spectroscopy (SERRDS) carotenoid signals were assessed. Results: Healthy subjects showed significantly (P <.001) higher mean concentrations of carotenoids compared to cancer subjects at Tbase. An increase in fluorescence intensity was detected in almost all patients after chemotherapy, especially after doxorubicin infusion. Furthermore, a decrease in the carotenoid concentration in the skin after chemotherapy was found. Conclusion: The SERRDS based noninvasive detection can be used as an indirect quantitative assessment of fluorescent chemotherapeutics. The lower carotenoid SERRDS intensities at Tbase might be due to cancerous diseases and co-medication. © 2020 The Authors. Skin Research and Technology Published by John Wiley & Sons Ltd.
- ItemLow resistance n-contact for UVC LEDs by a two-step plasma etching process(Bristol : IOP Publ., 2020) Cho, H.K.; Kang, J.H.; Sulmoni, L.; Kunkel, K.; Rass, J.; Susilo, N.; Wernicke, T.; Einfeldt, S.; Kneissl, M.The impact of plasma etching on the formation of low-resistance n-contacts on the AlGaN:Si current spreading layer during the chip fabrication of ultraviolet light-emitting diodes (UV LEDs) emitting at 265 nm is investigated. A two-step plasma etching process with a first rapid etching using BCl3/Cl2 gas mixture and a second slow etching step using pure Cl2 gas has been developed. The etching sequence provides smooth mesa side-walls and an n-AlGaN surface with reduced surface damage. Ohmic n-contacts with a contact resistivity of 3.5 10-4 Ωcm2 are obtained on Si-doped Al0.65Ga0.35N layers and the operating voltages of the UVC LEDs were reduced by 2 V for a current of 20 mA. © 2020 The Author(s). Published by IOP Publishing Ltd.
- ItemHigh-brightness broad-area diode lasers with enhanced self-aligned lateral structure(Bristol : IOP Publ., 2020) Elatta, M.; Brox, O.; Della Casa, P.; Maaßdorf, A.; Martin, D.; Wenzel, H.; Knigge, A.; Crump, P.Broad-area diode lasers with increased brightness and efficiency are presented, which are fabricated using an enhanced self-aligned lateral structure by means of a two-step epitaxial growth process with an intermediate etching step. In this structure, current-blocking layers in the device edges ensure current confinement under the central stripe, which can limit the detrimental effects of current spreading and lateral carrier accumulation on beam quality. It also minimizes losses at stripe edges, thus lowering the lasing threshold and increasing conversion efficiency, while maintaining high polarization purity. In the first realization of this structure, the current block is integrated within an extreme-triple-asymmetric epitaxial design with a thin p-doped side, meaning that the distance between the current block and the active zone can be minimized without added process complexity. Using this configuration, enhanced self-aligned structure devices with 90 µm stripe width and 4 mm resonator length show up to 20% lower threshold current, 21% narrower beam waist, and slightly higher (1.03 ) peak efficiency in comparison to reference devices with the same dimensions, while slope, divergence angle and polarization purity remain almost unchanged. These results correspond to an increase in brightness by up to 25%, and measurement results of devices with varying stripe widths follow the same trend. © 2020 The Author(s). Published by IOP Publishing Ltd.
- ItemImpact of the capture time on the series resistance of quantum-well diode lasers(Bristol : IOP Publ., 2020) Boni, A.; Wünsche, H.J.; Wenzel, H.; Crump, P.Electrons and holes injected into a semiconductor heterostructure containing quantum wells are captured with a finite time. We show theoretically that this very fact can cause a considerable excess contribution to the series resistivity and this is one of the main limiting factors to higher efficiency for GaAs based high-power lasers. The theory combines a standard microscopic-based model for the capture-escape processes in the quantum well with a drift-diffusion description of current flow outside the quantum well. Simulations of five GaAs-based devices differing in their Al-content reveal the root-cause of the unexpected and until now unexplained increase of the series resistance with decreasing heat sink temperature measured recently. The finite capture time results in resistances in excess of the bulk layer resistances (decreasing with increasing temperature) from 1 mΩ up to 30 mΩ in good agreement with the experiment. © 2020 The Author(s). Published by IOP Publishing Ltd.
- ItemLow-index quantum-barrier single-pass tapered semiconductor optical amplifiers for efficient coherent beam combining(Bristol : IOP Publ., 2020) Albrodt, P.; Niemeyer, M.; Elattar, M.; Hamperl, J.; Blume, G.; Ginolas, A.; Fricke, J.; Maaßdorf, A.; Georges, P.; Lucas-Leclin, G.; Paschke, K.; Crump, P.The requirements for coherent combination of high power GaAs-based single-pass tapered amplifiers are studied. Changes to the epitaxial layer structure are shown to bring higher beam quality and hence improved combining efficiency for one fixed device geometry. Specifically, structures with large vertical near field and low wave-guiding from the active region show 10% higher beam quality and coherent combining efficiency than reference devices. As a result, coherent combining efficiency is shown to be limited by beam quality, being directly proportional to the power content in the central lobe across a wide range of devices with different construction. In contrast, changes to the in-plane structure did not improve beam quality or combining efficiency. Although poor beam quality does correlate with increased optical intensities near the input aperture, locating monolithically-integrated absorption regions in these areas did not lead to any performance improvement. However, large area devices with subsequently improved cooling do achieve higher output powers. Phase noise can limit coherent combining, but this is shown to be small and independent of device design. Overall, tapered amplifiers are well suited for high power coherent combining applications. © 2020 The Author(s). Published by IOP Publishing Ltd.