53 results
Search Results
Now showing 1 - 10 of 53
- ItemStrain induced power enhancement of far-UVC LEDs on high temperature annealed AlN templates(Melville, NY : American Inst. of Physics, 2023) Knauer, A.; Kolbe, T.; Hagedorn, S.; Hoepfner, J.; Guttmann, M.; Cho, H.K.; Rass, J.; Ruschel, J.; Einfeldt, S.; Kneissl, M.; Weyers, M.High temperature annealed AlN/sapphire templates exhibit a reduced in-plane lattice constant compared to conventional non-annealed AlN/sapphire grown by metalorganic vapor phase epitaxy (MOVPE). This leads to additional lattice mismatch between the template and the AlGaN-based ultraviolet-C light emitting diode (UVC LED) heterostructure grown on these templates. This mismatch introduces additional compressive strain in AlGaN quantum wells resulting in enhanced transverse electric polarization of the quantum well emission at wavelengths below 235 nm compared to layer structures deposited on conventional MOVPE-grown AlN templates, which exhibit mainly transverse magnetic polarized emission. In addition, high temperature annealed AlN/sapphire templates also feature reduced defect densities leading to reduced non-radiative recombination. Based on these two factors, i.e., better outcoupling efficiency of the transverse electric polarized light and an enhanced internal quantum efficiency, the performance characteristic of far-UVC LEDs emitting at 231 nm was further improved with a cw optical output power of 3.5 mW at 150 mA.
- ItemA 310 nm Optically Pumped AlGaN Vertical-Cavity Surface-Emitting Laser(Washington, DC : ACS Publications, 2021) Hjort, Filip; Enslin, Johannes; Cobet, Munise; Bergmann, Michael A.; Gustavsson, Johan; Kolbe, Tim; Knauer, Arne; Nippert, Felix; Häusler, Ines; Wagner, Markus R.; Wernicke, Tim; Kneissl, Michael; Haglund, ÅsaUltraviolet light is essential for disinfection, fluorescence excitation, curing, and medical treatment. An ultraviolet light source with the small footprint and excellent optical characteristics of vertical-cavity surface-emitting lasers (VCSELs) may enable new applications in all these areas. Until now, there have only been a few demonstrations of ultraviolet-emitting VCSELs, mainly optically pumped, and all with low Al-content AlGaN cavities and emission near the bandgap of GaN (360 nm). Here, we demonstrate an optically pumped VCSEL emitting in the UVB spectrum (280-320 nm) at room temperature, having an Al0.60Ga0.40N cavity between two dielectric distributed Bragg reflectors. The double dielectric distributed Bragg reflector design was realized by substrate removal using electrochemical etching. Our method is further extendable to even shorter wavelengths, which would establish a technology that enables VCSEL emission from UVA (320-400 nm) to UVC (<280 nm). © 2020 American Chemical Society. All rights reserved.
- ItemOptimized diamond inverted nanocones for enhanced color center to fiber coupling(Melville, NY : American Inst. of Physics, 2021) Torun, Cem Güney; Schneider, Philipp-Immanuel; Hammerschmidt, Martin; Burger, Sven; Munns, Joseph H. D.; Schröder, TimNanostructures can be used for boosting the light outcoupling of color centers in diamond; however, the fiber coupling performance of these nanostructures is rarely investigated. Here, we use a finite element method for computing the emission from color centers in inverted nanocones and the overlap of this emission with the propagation mode in a single-mode fiber. Using different figures of merit, the inverted nanocone parameters are optimized to obtain maximal fiber coupling efficiency, free-space collection efficiency, or rate enhancement. The optimized inverted nanocone designs show promising results with 66% fiber coupling or 83% free-space coupling efficiency at the tin-vacancy center zero-phonon line wavelength of 619 nm. Moreover, when evaluated for broadband performance, the optimized designs show 55% and 76% for fiber coupling and free-space efficiencies, respectively, for collecting the full tin-vacancy emission spectrum at room temperature. An analysis of fabrication insensitivity indicates that these nanostructures are robust against imperfections. For maximum emission rate into a fiber mode, a design with a Purcell factor of 2.34 is identified. Finally, possible improvements offered by a hybrid inverted nanocone, formed by patterning into two different materials, are investigated and increase the achievable fiber coupling efficiency to 71%. © 2021 Author(s).
- ItemExtensive study of magneto-optical and optical properties of Cd1−xMnxTe between 675 and 1025 nm(New York, NY : American Inst. of Physics, 2023) Tyborski, Christoph; Hassan, Muhammad T.; Flisgen, Thomas; Schiemangk, Max; Wicht, AndreasWe determine Faraday rotations and measure the optical reflection and transmission from magneto-optical Cd1−xMnxTe crystals with various stoichiometric ratios. For wavelengths between 675 and 1025 nm, we derive Verdet constants, optical loss coefficients, and the complex indices of reflection that are relevant measures to find suitable stoichiometric ratios of Cd1−xMnxTe for the realization of miniaturized optical isolators. By reflection and transmission measurements, we determine the stoichiometric ratios of several different Cd1−xMnxTe crystals and discuss the observed dependence of the optical properties on the stoichiometric ratio with respect to their use in optical isolators. Finally, we show the relevant figure of merit, i.e., the ratio of Verdet constants and optical loss coefficients for Cd1−xMnxTe crystals with Mn contents ranging from x = 0.14 to x = 0.50.
- ItemHigh-temperature annealing of AlN films grown on 4H-SiC(New York, NY : American Inst. of Physics, 2020) Brunner, F.; Cancellara, L.; Hagedorn, S.; Albrecht, M.; Weyers, M.The effect of high-temperature annealing (HTA) at 1700 °C on AlN films grown on 4H-SiC substrates by metalorganic vapor phase epitaxy has been studied. It is shown that the structural quality of the AlN layers improves significantly after HTA similar to what has been demonstrated for AlN grown on sapphire. Dislocation densities reduce by one order of magnitude resulting in 8 × 108 cm-2 for a-type and 1 × 108 cm-2 for c-type dislocations. The high-temperature treatment removes pits from the surface by dissolving nanotubes and dislocations in the material. XRD measurements prove that the residual strain in AlN/4H-SiC is further relaxed after annealing. AlN films grown at higher temperature resulting in a lower as-grown defect density show only a marginal reduction in dislocation density after annealing. Secondary ion mass spectrometry investigation of impurity concentrations reveals an increase of Si after HTA probably due to in-diffusion from the SiC substrate. However, C concentration reduces considerably with HTA that points to an efficient carbon removal process (i.e., CO formation). © 2020 Author(s).
- ItemTemperature dependence of the complex permittivity in microwave range of some industrial polymers(New York, NY : American Inst. of Physics, 2022) Porteanu, Horia-Eugen; Kaempf, Rudolf; Flisgen, Thomas; Heinrich, WolfgangThe microwave properties of a number of polymers common in industry are investigated. A cylindrical resonator in the TM012 mode is used. The cavity perturbation method and detailed COMSOL simulations are applied for extracting the complex permittivity as a function of temperature. The results are useful for the design of plastic processing tools by heating with electromagnetic fields. The intrinsic parameters of absorption are derived based on two exponential decays: polarization and Arrhenius dependence of the decay times on temperature.
- ItemDiode laser based light sources for biomedical applications(Hoboken, NJ : Wiley, 2012) Müller, André; Marschall, Sebastian; Jensen, Ole Bjarlin; Fricke, Jörg; Wenzel, Hans; Sumpf, Bernd; Andersen, Peter E.Diode lasers are by far the most efficient lasers currently available. With the ever-continuing improvement in diode laser technology, this type of laser has become increasingly attractive for a wide range of biomedical applications. Compared to the characteristics of competing laser systems, diode lasers simultaneously offer tunability, high-power emission and compact size at fairly low cost. Therefore, diode lasers are increasingly preferred in important applications, such as photocoagulation, optical coherence tomography, diffuse optical imaging, fluorescence lifetime imaging, and terahertz imaging. This review provides an overview of the latest development of diode laser technology and systems and their use within selected biomedical applications.
- ItemContinuous Wave THz System Based on an Electrically Tunable Monolithic Dual Wavelength Y-Branch DBR Diode Laser(New York, NY : Springer, 2020) Gwaro, Jared O.; Brenner, Carsten; Theurer, L.S.; Maiwald, M.; Sumpf, Bernd; Hofmann, Martin R.We analyse the use of a tunable dual wavelength Y-branch DBR laser diode for THz applications. The laser generates electrically tunable THz difference frequencies in the range between 100 and 300 GHz. The optical beats are tuned via current injection into a micro-resistor heater integrated on top of one of the distributed Bragg reflector (DBR) section of the diode. The laser is integrated in a homodyne THz system employing fiber coupled ion-implanted LT-GaAs log spiral antennas. The applicability of the developed system in THz spectroscopy is demonstrated by evaluating the spectral resonances of a THz filter as well as in THz metrology in thickness determination of a polyethylene sample.
- ItemCathodoluminescence and TEM investigations of structural and optical properties of AlGaN on epitaxial laterally overgrown AlN/sapphire templates(Milton Park : Taylor & Francis, 2013) Zeimer, U.; Mogilatenko, A.; Kueller, V.; Knauer, A.; Weyers, M.Surface steps as high as 15 nm on up to 10 μm thick AlN layers grown on patterned AlN/sapphire templates play a major role for the structural and optical properties of AlxGa1−xN layers with x ≥ 0.5 grown subsequently by metalorganic vapour phase epitaxy. The higher the Ga content in these layers is, the stronger is the influence of the surface morphology on their properties. For x = 0.5 not only periodic inhomogeneities in the Al content due to growth of Ga-rich facets are observed by cathodoluminescence, but these facets give rise to additional dislocation formation as discovered by annular dark-field scanning transmission electron microscopy. For AlxGa1−xN layers with x = 0.8 the difference in Al content between facets and surrounding material is much smaller. Therefore, the threading dislocation density (TDD) is only defined by the TDD in the underlying epitaxially laterally overgrown (ELO) AlN layer. This way high quality Al0.8Ga0.2N with a thickness up to 1.5 μm and a TDD ≤ 5x108 cm−2 was obtained.
- ItemNormally-off GaN transistors for power applications(Milton Park : Taylor & Francis, 2014) Hilt, O.; Bahat-Treidel, E.; Brunner, F.; Knauer, A.; Zhytnytska, R.; Kotara, P.; Wuerfl, J.Normally-off high voltage GaN-HFETs for switching applications are presented. Normally-off operation with threshold voltages of 1 V and more and with 5 V gate swing has been obtained by using p-type GaN as gate. Different GaN-based buffer types using doping and backside potential barriers have been used to obtain blocking strengths up to 1000 V. The increase of the dynamic on-state resistance is analyzed for the different buffer types. The best trade-off between low dispersion and high blocking strength was obtained for a modified carbon-doped GaN-buffer that showed a 2.6x increase of the dynamic on-state resistance for 500 V switching as compared to switching from 20 V off-state drain bias. Device operation up to 200 °C ambient temperature without any threshold voltage shift is demonstrated.