Filters

2015 - 20182

More filters

20192
Reset filters

Settings

DDC: 620 × Publisher: Cambridge : Cambridge University Press ×

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    High strength nanocrystalline Cu–Co alloys with high tensile ductility
    (Cambridge : Cambridge University Press, 2018) Bachmaier, Andrea; Rathmayr, Georg Benedikt; Schmauch, Jörg; Schell, Norbert; Stark, Andreas; de Jonge, Niels; Pippan, Reinhard
    A supersaturated single-phase Cu–26 at.% Co alloy was produced by high-pressure torsion deformation, leading to a nanocrystalline microstructure with a grain size smaller than 100 nm. The nonequilibrium solid solution decomposed during subsequent isothermal annealing. In situ high-energy X-ray diffraction was used to map changes linked to the separating phases, and the development of a nanoscale Cu–Co composite structure was observed. To gain further information about the relationship of the microstructure and the mechanical properties after phase separation, uniaxial tensile tests were conducted on as-deformed and isothermally annealed samples. Based on the in situ diffraction data, different isothermal annealing temperatures were chosen. Miniaturized tensile specimens with a round cross section were tested, and an image-based data evaluation method enabled the evaluation of true stress–strain curves and strain hardening behavior. The main results are as follows: all microstructural states showed high strength and ductility, which was achieved by a combination of strain-hardening and strain-rate hardening.
  • Thumbnail Image
    Item
    Processing of Al–12Si–TNM composites by selective laser melting and evaluation of compressive and wear properties
    (Cambridge : Cambridge University Press, 2015) Prashantha, Konda G.; Scudino, Sergio; Chaubey, Anil K.; Löber, Lukas; Wang, Pei; Attar, Hooyar; Schimansky, Frank P.; Pyczak, Florian; Eckert, Jürgen
    Al-12Si (80 vol%)-Ti52.4Al42.2Nb4.4Mo0.9B0.06 (at.%) (TNM) composites were successfully produced by the selective laser melting (SLM). Detailed structural and microstructural analysis shows the formation of the Al6MoTi intermetallic phase due to the reaction of the TNM reinforcement with the Al-12Si matrix during SLM. Compression tests reveal that the composites exhibit significantly improved properties (∼140 and ∼160 MPa higher yield and ultimate compressive strengths, respectively) compared with the Al-12Si matrix. However, the samples break at ∼6% total strain under compression, thus showing a reduced plasticity of the composites. Sliding wear tests were carried out for both the Al-12Si matrix and the Al-12Si-TNM composites. The composites perform better under sliding wear conditions and the wear rate increases with increasing loads. At high loads, the wear takes place at three different rates and the wear rate decreases with increasing experiment duration.