2 results
Search Results
Now showing 1 - 2 of 2
- ItemCharacteristics of austenitic stainless steel nitrided in a hybrid glow discharge plasma(New York, NY : Springer, 2009) Oliveira, R.M.; Ueda, M.; Silva, L.L.G.; Reuther, H.; Lepienski, C.M.A nitriding process based on two distinct nitrogen glow discharge modes, with sample temperatures ranging from 380 °Cto480°C, was employed to treat the surface of austenitic stainless steel (SS 304). The temperature is controlled exclusively by switching the operation conditions of the discharges. First mode of operation is the conventional one, named cathodic, which runs at higher pressure values (1 mbar) in comparison to the second mode, named anodic, which runs at the pressure range of 10-3 -10-2 mbar. Cathodic mode is used to quickly heat the sample holder, by the high ion flux. On the other hand, in the anodic mode, due to the lower operation pressure, higher effective ion acceleration takes place, which allows deeper ion implantation into the sample surface. This hybrid process was thoroughly explored regarding the duty cycle and conditions of operation, to achieve optimal performance of the treatments, which led to the attainment of surface hardness for samples of AISI SS 304 as high as 20 GPa and improvements including higher elastic modulus and resistance against corrosion. Detailed comparison among samples treated by this process with others treated by conventional method was done using nanoindentation, Auger Electron Spectroscopy (AES) and corrosion resistance testing.
- ItemMechanical performance and corrosion behaviour of Zr-based bulk metallic glass produced by selective laser melting(Amsterdam : Elsevier B.V., 2020) Deng, L.; Gebert, A.; Zhang, L.; Chen, H.Y.; Gu, D.D.; Kühn, U.; Zimmermann, M.; Kosiba, K.; Pauly, S.Nearly fully dense, glassy Zr52.5Cu17.9Ni14.6Al10Ti5 bulk specimens were fabricated by selective laser melting (SLM) and their behaviour during compressive loading, during wear testing and in a corrosive medium was investigated. Their performance was compared with as-cast material of the same composition. The additively manufactured samples exhibit a yield strength around 1700 MPa combined with a plastic strain of about 0.5% after yielding despite the residual porosity of 1.3%, which is distributed uniformly in the samples. The propagation of shear bands in the bulk metallic glass prepared by SLM was studied. The specific wear rate and the worn surfaces demonstrated that similar wear mechanisms are active in the SLM and the as-cast samples. Hence, manufacturing the glass in layers does not adversely affect the wear properties. The same holds for the corrosion tests, which were carried out in 0.01 M Na2SO4 and 0.1 M NaCl electrolyte. The anodic polarization curves of SLM samples and as-cast samples revealed a similar corrosion behaviour. However, the SLM samples have a slightly reduced susceptibility to pitting corrosion and exhibit an improved surface healing ability, which might be attributed to an improved homogeneity of the additively manufactured glass.