6 results
Search Results
Now showing 1 - 6 of 6
- ItemSite-controlled formation of single Si nanocrystals in a buried SiO2 matrix using ion beam mixing(Frankfurt am Main : Beilstein-Institut zur Förderung der Chemischen Wissenschaften, 2018) Xu, X.; Prüfer, T.; Wolf, D.; Engelmann, H.-J.; Bischoff, L.; Hübner, R.; Heinig, K.-H.; Möller, W.; Facsko, S.; von Borany, J.; Hlawacek, G.For future nanoelectronic devices - such as room-temperature single electron transistors - the site-controlled formation of single Si nanocrystals (NCs) is a crucial prerequisite. Here, we report an approach to fabricate single Si NCs via medium-energy Si+ or Ne+ ion beam mixing of Si into a buried SiO2 layer followed by thermally activated phase separation. Binary collision approximation and kinetic Monte Carlo methods are conducted to gain atomistic insight into the influence of relevant experimental parameters on the Si NC formation process. Energy-filtered transmission electron microscopy is performed to obtain quantitative values on the Si NC size and distribution in dependence of the layer stack geometry, ion fluence and thermal budget. Employing a focused Ne+ beam from a helium ion microscope, we demonstrate site-controlled self-assembly of single Si NCs. Line irradiation with a fluence of 3000 Ne+/nm2 and a line width of 4 nm leads to the formation of a chain of Si NCs, and a single NC with 2.2 nm diameter is subsequently isolated and visualized in a few nanometer thin lamella prepared by a focused ion beam (FIB). The Si NC is centered between the SiO2 layers and perpendicular to the incident Ne+ beam.
- ItemSpin pumping at interfaces with ferro- and paramagnetic Fe60Al40films acting as spin source and spin sink(Melville, NY : American Inst. of Physics, 2022) Strusch, T.; Lenz, K.; Meckenstock, R.; Bali, R.; Ehrler, J.; Lindner, J.; Fassbender, J.; Farle, M.; Potzger, K.; Semisalova, A.We present a study of spin pumping efficiency and determine the spin mixing conductance and spin diffusion length in thin bilayer films based on 3d transition metal alloy Fe60Al40. Due to its magnetostructural phase transition, Fe60Al40 can be utilized as a ferromagnetic (FM) or paramagnetic (PM) material at the same temperature depending on its structural order; thus a thin Fe60Al40 film can act as a spin source or a spin sink when interfaced with a paramagnet or a ferromagnet, respectively. Ferromagnetic resonance measurements were performed in a frequency range of 5-35 GHz on bilayer films composed of FM-Fe60Al40/Pd and PM-Fe60Al40/Ni80Fe20 (permalloy). The increase in damping with the thickness of the paramagnetic layer was interpreted as a result of spin pumping into the paramagnet. We determine the spin mixing conductance g P d ↑↓ = (3.8 ± 0.5) × 10 18 m - 2 at the FM-Fe60Al40/Pd interface and the spin diffusion length λ P d = 9.1 ± 2.0 nm in Pd. For the PM-Fe60Al40/permalloy interface, we find a spin mixing conductance g F e A l ↑↓ = (2.1 ± 0.2) × 10 18 m - 2 and a spin diffusion length λ F e A l = 11.9 ± 0.2 nm for PM-Fe60Al40. The demonstrated bi-functionality of the Fe60Al40 alloy in spin pumping structures may be promising for spintronic applications.
- ItemFrom Large Deviations to Semidistances of Transport and Mixing: Coherence Analysis for Finite Lagrangian Data(New York, NY : Springer, 2018) Koltai, Péter; Renger, D.R. MichielOne way to analyze complicated non-autonomous flows is through trying to understand their transport behavior. In a quantitative, set-oriented approach to transport and mixing, finite time coherent sets play an important role. These are time-parametrized families of sets with unlikely transport to and from their surroundings under small or vanishing random perturbations of the dynamics. Here we propose, as a measure of transport and mixing for purely advective (i.e., deterministic) flows, (semi)distances that arise under vanishing perturbations in the sense of large deviations. Analogously, for given finite Lagrangian trajectory data we derive a discrete-time-and-space semidistance that comes from the “best” approximation of the randomly perturbed process conditioned on this limited information of the deterministic flow. It can be computed as shortest path in a graph with time-dependent weights. Furthermore, we argue that coherent sets are regions of maximal farness in terms of transport and mixing, and hence they occur as extremal regions on a spanning structure of the state space under this semidistance—in fact, under any distance measure arising from the physical notion of transport. Based on this notion, we develop a tool to analyze the state space (or the finite trajectory data at hand) and identify coherent regions. We validate our approach on idealized prototypical examples and well-studied standard cases.
- ItemComputer modeling of single-layer nanocluster formation in a thin SiO2 layer buried in Si by ion mixing and thermal phase decomposition(College Park, MD : American Institute of Physics, 2019) Prüfer, T.; Möller, W.; Heinig, K.-H.; Wolf, D.; Engelmann, H.-J.; Xu, X.; Von Borany, J.A single sheet of Si nanoclusters with an average diameter of about 2 nm has been formed in a 30 nm Si/7 nm SiO2/Si layer stack by 50 and 60 keV Si+ ion-beam mixing at room temperature and fluences between 8.5 ⋯ 1015 and 2.6 ⋯ 1016 ions/cm2 and by subsequent thermal annealing at a temperature above 1000 °C. Computer modeling of the process is accomplished by TRIDYN dynamic ballistic simulation of ion mixing and subsequent lattice kinetic Monte Carlo simulation of the phase decomposition of substoichiometric silicon oxide into Si nanoclusters in a SiO2 matrix. The simulation algorithms are briefly described with special emphasis on the choice of governing parameters for the present system. In comparison to the experimental results, it is concluded that the predicted ion mixing profiles overestimate the interface broadening. This discrepancy is attributed to the neglect of chemical driving forces in connection with thermal-spike induced diffusion, which tends to reconstitute the Si/SiO2 interfaces. With a corresponding correction and a suitable number of Monte Carlo steps, the experimentally obtained areal densities and average diameters of the nanoclusters are successfully reproduced.
- ItemPolyelectrolyte complex nanoparticles of poly(ethyleneimine) and poly(acrylic acid): Preparation and applications(Basel : MDPI AG, 2011) Müller, M.; Keßler, B.; Fröhlich, J.; Poeschla, S.; Torger, B.In this contribution we outline polyelectrolyte (PEL) complex (PEC) nanoparticles, prepared by mixing solutions of the low cost PEL components poly(ethyleneimine) (PEI) and poly(acrylic acid) (PAC). It was found, that the size and internal structure of PEI/PAC particles can be regulated by process, media and structural parameters. Especially, mixing order, mixing ratio, PEL concentration, pH and molecular weight, were found to be sensible parameters to regulate the size (diameter) of spherical PEI/PAC nanoparticles, in the range between 80-1,000 nm, in a defined way. Finally, applications of dispersed PEI/PAC particles as additives for the paper making process, as well as for drug delivery, are outlined. PEI/PAC nanoparticles mixed directly on model cellulose film showed a higher adsorption level applying the mixing order 1. PAC 2. PEI compared to 1. PEI 2. PAC. Surface bound PEI/PAC nanoparticles were found to release a model drug compound and to stay immobilized due to the contact with the aqueous release medium.
- ItemSynthesis and characterization of MgAl-DBS LDH/PLA composite by sonication-assisted masterbatch (SAM) melt mixing method(Cambridge : RSC, 2019) Quispe-Dominguez, Roger; Naseem, Sajid; Leuteritz, Andreas; Kuehnert, InesThis research work is based on the comparison of the mixing phenomena of magnesium-aluminum (MgAl) layered double hydroxides (LDHs) intercalated by dodecylbenzene sulfonate (MgAl-DBS) in poly(lactic acid) (PLA). Two mixing techniques were used to compare the dispersion of LDHs in PLA such as sonication-assisted masterbatch (SAM) melt mixing and direct melting (DM) methods. MgAl LDHs synthesized by the urea hydrolysis method and intercalated with DBS anions using anion exchange reaction and were used in different ratios in PLA (1.25, 2.5, and 5 wt%). MgAl LDHs and their anion intercalation were studied by the X-ray diffraction analysis (XRD) method. Different properties of LDH/PLA composites were compared to analyze the effect of these mixing techniques. Dispersion and exfoliation of LDHs in PLA were investigated by X-ray diffraction analysis (XRD) and transmission electron microscopy (TEM). Influences on the rheological properties were evaluated by analyzing the complex viscosities (η*), storage modulus (G′) and loss modulus (G′′) by using a rheometer. The thermal properties, thermal stability and effect on crystallinity of composites made with the two mixing techniques were analyzed by thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC) respectively. The mixing mechanism and amount of MgAl-DBS LDHs have a notable effect on the properties of PLA composites with sonication-assisted masterbatch melt mixing techniques giving better dispersion of LDHs in PLA composites as compared to direct melt mixing. © The Royal Society of Chemistry.