Influence of surface treatment on metal dusting resistance of welds

Abstract

Welds of the commercial Ni‐based alloys 602 CA, 699 XA, 601 and 690 were exposed under harsh metal dusting conditions. The pit formation was compared for as‐welded, brushed, ground, glass bead blasted, steel shot peened and dry cathodic pickled surfaces. Surface treatments were applied by industrial partners. When (stainless) steels were involved in the surface treatment, Fe contaminations acted as catalyst sites for pit initiation. A fast metal dusting attack was also observed on dry cathodic pickled samples. A beneficial effect was attributed to deformation of the sub‐surface zone, as it provides diffusion paths for oxide formers (by grinding and glass bead blasting). In the same region, formation of α‐Cr (BCC) precipitates was observed. The best performance was found for samples where the weld bead was fully flattened by grinding to P40 grit. In addition, it was demonstrated that on‐site slurry aluminization further enhances the resistance against metal dusting attack.