68 results
Search Results
Now showing 1 - 10 of 68
- ItemLabel free sensing of creatinine using a 6 GHz CMOS near-field dielectric immunosensor(Cambridge : Royal Society of Chemistry, 2015) Guha, S.; Warsinke, A.; Tientcheu, Ch.M.; Schmalz, K.; Meliani, C.; Wenger, Ch.In this work we present a CMOS high frequency direct immunosensor operating at 6 GHz (C-band) for label free determination of creatinine. The sensor is fabricated in standard 0.13 μm SiGe:C BiCMOS process. The report also demonstrates the ability to immobilize creatinine molecules on a Si3N4 passivation layer of the standard BiCMOS/CMOS process, therefore, evading any further need of cumbersome post processing of the fabricated sensor chip. The sensor is based on capacitive detection of the amount of non-creatinine bound antibodies binding to an immobilized creatinine layer on the passivated sensor. The chip bound antibody amount in turn corresponds indirectly to the creatinine concentration used in the incubation phase. The determination of creatinine in the concentration range of 0.88–880 μM is successfully demonstrated in this work. A sensitivity of 35 MHz/10 fold increase in creatinine concentration (during incubation) at the centre frequency of 6 GHz is gained by the immunosensor. The results are compared with a standard optical measurement technique and the dynamic range and sensitivity is of the order of the established optical indication technique. The C-band immunosensor chip comprising an area of 0.3 mm2 reduces the sensing area considerably, therefore, requiring a sample volume as low as 2 μl. The small analyte sample volume and label free approach also reduce the experimental costs in addition to the low fabrication costs offered by the batch fabrication technique of CMOS/BiCMOS process.
- ItemCharge pump design in 130 nm SiGe BiCMOS technology for low-noise fractional-N PLLs(München : European Geopyhsical Union, 2015) Kucharski, M.; Herzel, F.This paper presents a numerical comparison of charge pumps (CP) designed for a high linearity and a low noise to be used in a fractional-N phase-locked loop (PLL). We consider a PLL architecture, where two parallel CPs with DC offset are used. The CP for VCO fine tuning is biased at the output to keep the VCO gain constant. For this specific architecture, only one transistor per CP is relevant for phase detector linearity. This can be an nMOSFET, a pMOSFET or a SiGe HBT, depending on the design. The HBT-based CP shows the highest linearity, whereas all charge pumps show similar device noise. An internal supply regulator with low intrinsic device noise is included in the design optimization.
- ItemSelf-calibrating highly sensitive dynamic capacitance sensor: Towards rapid sensing and counting of particles in laminar flow systems(Cambridge : Royal Society of Chemistry, 2015) Guha, S.; Schmalz, K.; Wenger, Ch.; Herzel, F.In this report we propose a sensor architecture and a corresponding read-out technique on silicon for the detection of dynamic capacitance change. This approach can be applied to rapid particle counting and single particle sensing in a fluidic system. The sensing principle is based on capacitance variation of an interdigitated electrode (IDE) structure embedded in an oscillator circuit. The capacitance scaling of the IDE results in frequency modulation of the oscillator. A demodulator architecture is employed to provide a read-out of the frequency modulation caused by the capacitance change. A self-calibrating technique is employed at the read-out amplifier stage. The capacitance variation of the IDE due to particle flow causing frequency modulation and the corresponding demodulator read-out has been analytically modelled. Experimental verification of the established model and the functionality of the sensor chip were shown using a modulating capacitor independent of fluidic integration. The initial results show that the sensor is capable of detecting frequency changes of the order of 100 parts per million (PPM), which translates to a shift of 1.43 MHz at 14.3 GHz operating frequency. It is also shown that a capacitance change every 3 μs can be accurately detected.
- ItemAtomically controlled CVD processing of group IV semiconductors for ultra-large-scale integrations(Bristol : IOP Publishing, 2012) Murota, Junichi; Sakuraba, Masao; Tillack, BerndOne of the main requirements for ultra-large-scale integrations (ULSIs) is atomic-order control of process technology. Our concept of atomically controlled processing is based on atomic-order surface reaction control by CVD. By ultraclean low-pressure CVD using SiH4 and GeH4 gases, high-quality low-temperature epitaxial growth of Si1−xGex (100) (x=0–1) with atomically flat surfaces and interfaces on Si(100) is achieved. Self-limiting formation of 1–3 atomic layers of group IV or related atoms in the thermal adsorption and reaction of hydride gases on Si1-xGex (100) are generalized based on the Langmuir-type model. By the Si epitaxial growth on top of the material already-formed on Si(100), N, B and C atoms are confined within about a 1 nm thick layer. In Si cap layer growth on the P atomic layer formed on Si1−xGex (100), segregation of P atoms is suppressed by using Si2H6 instead of SiH4 at a low temperature of 450 °C. Heavy C atomic-layer doping suppresses strain relaxation as well as intermixing between Si and Ge at the Si1−xGex/Si heterointerface. It is confirmed that higher carrier concentration and higher carrier mobility are achieved by atomic-layer doping. These results open the way to atomically controlled technology for ULSIs.
- ItemRoom temperature direct band gap emission from Ge p-i-n heterojunction photodiodes(London : Hindawi, 2012) Kasper, E.; Oehme, M.; Arguirov, T.; Werner, J.; Kittler, M.; Schulze, J.Room temperature direct band gap emission is observed for Si-substrate-based Ge p-i-n heterojunction photodiode structures operated under forward bias. Comparisons of electroluminescence with photoluminescence spectra allow separating emission from intrinsic Ge (0.8 eV) and highly doped Ge (0.73 eV). Electroluminescence stems fromcarrier injection into the intrinsic layer, whereas photoluminescence originates from the highly n-doped top layer because the exciting visible laser wavelength is strongly absorbed in Ge. High doping levels led to an apparent band gap narrowing from carrier-impurity interaction. The emission shifts to higher wavelengths with increasing current level which is explained by device heating. The heterostructure layer sequence and the light emitting device are similar to earlier presented photodetectors. This is an important aspect for monolithic integration of silicon microelectronics and silicon photonics.
- ItemPlasma enhanced complete oxidation of ultrathin epitaxial praseodymia films on Si(111)(Basel : MDPI, 2015) Kuschel, Olga; Dieck, Florian; Wilkens, Henrik; Gevers, Sebastian; Rodewald, Jari; Otte, Christian; Zoellner, Marvin Hartwig; Niu, Gang; Schroeder, Thomas; Wollschläger, JoachimPraseodymia films have been exposed to oxygen plasma at room temperature after deposition on Si(111) via molecular beam epitaxy. Different parameters as film thickness, exposure time and flux during plasma treatment have been varied to study their influence on the oxygen plasma oxidation process. The surface near regions have been investigated by means of X-ray photoelectron spectroscopy showing that the plasma treatment transforms the stoichiometry of the films from Pr2O3 to PrO2. Closer inspection of the bulk properties of the films by means of synchrotron radiation based X-ray reflectometry and diffraction confirms this transformation if the films are thicker than some critical thickness of 6 nm. The layer distance of these films is extremely small verifying the completeness of the plasma oxidation process. Thinner films, however, cannot be transformed completely. For all films, less oxidized very thin interlayers are detected by these experimental techniques.
- ItemMAC and baseband processors for RF-MIMO WLAN(London : BioMed Central, 2011) Stamenkovic, Zoran; Tittelbach-Helmrich, Klaus; Krstic, Milos; Ibanez, Jesus; Elvira, Victor; Santamaria, IgnacioThe article describes hardware solutions for the IEEE 802.11 medium access control (MAC) layer and IEEE 802.11a digital baseband in an RF-MIMO WLAN transceiver that performs the signal combining in the analogue domain. Architecture and implementation details of the MAC processor including a hardware accelerator and a 16-bit MAC-physical layer (PHY) interface are presented. The proposed hardware solution is tested and verified using a PHY link emulator. Architecture, design, implementation, and test of a reconfigurable digital baseband processor are described too. Description includes the baseband algorithms (the main blocks being MIMO channel estimation and Tx-Rx analogue beamforming), their FPGA-based implementation, baseband printed-circuit-board, and real-time tests.
- ItemControlling the physics and chemistry of binary and ternary praseodymium and cerium oxide systems(Cambridge : Royal Society of Chemistry, 2015) Niu, Gang; Zoellner, Marvin Hartwig; Schroeder, Thomas; Schaefer, Andreas; Jhang, Jin-Hao; Zielasek, Volkmar; Bäumer, Marcus; Wilkens, Henrik; Wollschläger, Joachim; Olbrich, Reinhard; Lammers, Christian; Reichling, MichaelRare earth praseodymium and cerium oxides have attracted intense research interest in the last few decades, due to their intriguing chemical and physical characteristics. An understanding of the correlation between structure and properties, in particular the surface chemistry, is urgently required for their application in microelectronics, catalysis, optics and other fields. Such an understanding is, however, hampered by the complexity of rare earth oxide materials and experimental methods for their characterisation. Here, we report recent progress in studying high-quality, single crystalline, praseodymium and cerium oxide films as well as ternary alloys grown on Si(111) substrates. Using these well-defined systems and based on a systematic multi-technique surface science approach, the corresponding physical and chemical properties, such as the surface structure, the surface morphology, the bulk–surface interaction and the oxygen storage/release capability, are explored in detail. We show that specifically the crystalline structure and the oxygen stoichiometry of the oxide thin films can be well controlled by the film preparation method. This work leads to a comprehensive understanding of the properties of rare earth oxides and highlights the applications of these versatile materials. Furthermore, methanol adsorption studies are performed on binary and ternary rare earth oxide thin films, demonstrating the feasibility of employing such systems for model catalytic studies. Specifically for ceria systems, we find considerable stability against normal environmental conditions so that they can be considered as a “materials bridge” between surface science models and real catalysts. Graphical abstract: Controlling the physics and chemistry of binary and ternary praseodymium and cerium oxide systems
- ItemHigh-resolution characterization of the forbidden Si 200 and Si 222 reflections(Chester : International Union of Crystallography, 2015) Zaumseil, P.The occurrence of the basis-forbidden Si 200 and Si 222 reflections in specular X-ray diffraction !–2 scans is investigated in detail as a function of the inplane sample orientation. This is done for two different diffractometer types with low and high angular divergence perpendicular to the diffraction plane. It is shown that the reflections appear for well defined conditions as a result of multiple diffraction, and not only do the obtained peaks vary in intensity but additional features like shoulders or even subpeaks may occur within a 2 range of about 2.5 . This has important consequences for the detection and verification of layer peaks in the corresponding angular range.
- ItemSupport for a long lifetime and short end-to-end delays with TDMA protocols in sensor networks(London : Hindawi, 2012) Brzozowski, Marcin; Salomon, Hendrik; Langendoerfer, PeterThis work addresses a tough challenge of achieving two opposing goals: ensuring long lifetimes and supporting short end-to-end delays in sensor networks. Obviously, sensor nodes must wake up often to support short delays in multi-hop networks. As event occurs seldom in common applications, most wake-up are useless: nodes waste energy due to idle listening. We introduce a set of solutions, referred to as LETED (limiting end-to-end delays), which shorten the wake-up periods, reduce idle listening, and save energy. We exploit hardware features of available transceivers that allow early detection of idle wake-up periods. This feature is introduced on top of our approach to reduce idle listening stemming from clock drift owing to the estimation of run-time drift. To evaluate LETED and other MAC protocols that support short end-to-end delays we present an analytical model, which considers almost 30 hardware and software parameters. Our evaluation revealed that LETED reduces idle listening by 15x and more against similar solutions. Also, LETED outperforms other protocols and provides significant longer lifetimes. For example, nodes with LETED work 8x longer than those with a common TDMA and 2x-3x longer than with protocols based on preamble sampling, like B-MAC.