8 results
Search Results
Now showing 1 - 8 of 8
- ItemSubsequent treatment of leafy vegetables with low doses of UVB-radiation does not provoke cytotoxicity, genotoxicity, or oxidative stress in a human liver cell model(Amsterdam [u.a.] : Elsevier, 2021) Wiesner-Reinhold, Melanie; Dutra Gomes, João Victor; Herz, Corinna; Tran, Hoai Thi Thu; Baldermann, Susanne; Neugart, Susanne; Filler, Thomas; Glaab, Johannes; Einfeldt, Sven; Schreiner, Monika; Lamy, EvelynUltraviolet B (UVB) radiation in low but ecological-relevant doses acts as a regulator in the plant's secondary metabolism. This study investigates the effect of UVB radiation from light-emitting diodes (LEDs) [peak wavelength of (290 ± 2) nm] on the biosynthesis of health-promoting secondary plant metabolites (carotenoids, phenolic compounds, and glucosinolates) of green and red leafy vegetables of Lactuca sativa, Brassica campestris, and Brassica juncea followed by evaluation of potential adverse effects in a human liver cell model. UVB radiation led to a significant increase in individual secondary plant metabolites, especially of phenolic compounds and glucosinolates, e.g. alkenyl glucosinolate content. Kaempferol und quercetin glycoside concentrations were also significantly increased compared to untreated plants. The plant extracts from Lactuca sativa, Brassica campestris, and Brassica juncea were used to assess cytotoxicity (WST-1 assay and trypan blue staining), genotoxicity (Comet assay), and production of reactive oxygen species (EPR) using metabolically competent human-derived HepG2 liver cells. No adverse effects in terms of cytotoxicity, genotoxicity, or oxidative stress were detected in an extract concentration ranging from 3.125 to 100 μg ml−1. Notably, only at very high concentrations were marginal cytostatic effects observed in extracts from UVB-treated as well as untreated plants. In conclusion, the application of UVB radiation from LEDs changes structure-specific health-promoting secondary plant metabolites without damaging the plants. The treatment did not result in adverse effects at the human cell level. Based on these findings, UVB LEDs are a future alternative, promising light source to replace currently commonly used high-pressure sodium lamps in greenhouses.
- ItemEnergy-dependent dielectric tensor axes in monoclinic α-3,4,9,10-perylene tetracarboxylic dianhydride(Amsterdam [u.a.] : Elsevier, 2023) Alonso, M.I.; Garriga, M.; Ossó, J.O.; Schreiber, F.; Scholz, R.We have determined the complex dielectric tensor of single crystalline 3,4,9,10-perylene tetracarboxylic dianhydride (α-PTCDA) as a function of energy in the range between 1.4 and 5.0 eV. The results obtained reflect the monoclinic symmetry of the crystal: The principal axes of the real and the imaginary part of the tensor in general do not coincide and show chromatic dispersion. Monoclinic behavior allows rotation of the components ɛX and ɛZ in the plane perpendicular to the unique symmetry axis Y. The experimental results indicate that the energies of the optical transitions observed in the weak ɛX component coincide with energies in which a resonance effect due to coupling with the stronger ɛZ component occurs. These resonances appear at energies close to electronic excitations such as the optical gap, the transport gap and the highest occupied molecular orbital–lowest unoccupied molecular orbital (HOMO–LUMO) peak-to-peak gap and their assignments are discussed based on theoretical calculations.
- ItemSpontaneous fluctuations in a plasma ion assisted deposition – correlation between deposition conditions and vanadium oxide thin film growth(Amsterdam [u.a.] : Elsevier, 2021) Frank, Anna; Dias, Miguel; Hieke, Stefan; Kruth, Angela; Scheu, ChristinaIn this work correlations between thin film crystallinity of plasma ion assisted electron beam evaporated vanadium oxide (VOx) and fluctuations of the deposition parameters during the growth process could be observed by in situ monitoring deposition conditions and electron microscopy studies. In the presented case, unintentional fluctuations in the gas flow at the plasma source caused by inhomogeneous melting of the target material lead to an increase in discharge current and therefore a decrease of the oxygen flow in the plasma source, resulting in the formation of highly crystalline bands due to a temporary increase in energy flux. The major part of the VOx thin film consists of a large number of nanocrystals embedded in an amorphous phase. In-depth structural analysis confirms a mixture of V2O5, in different modifications, VO2, as well as the mixed-valence oxides V4O9 and V6O13, for nanocrystalline parts and crystalline bands. These differ mainly in the degree of crystallinity being influenced by variations in discharge current, and partly in the amount of higher oxidized vanadium oxides. In future, precisely controlled variation of plasma source conditions will open up pathways to control and tailor crystallinity of electron beam evaporated thin films, allowing for production methods for patterned thin films or layers with graduated crystallinity. This may give rise to a new class of coatings of nanohybrids combining amorphous VOx with low electrical conductivity and crystalline domains providing a higher electrical conductivity which is useful for electrochromic displays, smart windows, and solar cells.
- ItemInfluence of molecular weight of polycation polydimethyldiallylammonium and carbon nanotube content on electric conductivity of layer-by-layer films(Amsterdam [u.a.] : Elsevier, 2022) Neuber, Sven; Sill, Annekatrin; Efthimiopoulos, Ilias; Nestler, Peter; Fricke, Katja; Helm, Christiane A.For biological and engineering applications, nm-thin films with high electrical conductivity and tunable sheet resistance are desirable. Multilayers of polydimethyldiallylammonium chloride (PDADMA) with two different molecular weights (322 and 44.3 kDa) and oxidized carbon nanotubes (CNTs) were constructed using the layer-by-layer technique. The surface coverage of the CNTs was monitored with a selected visible near infrared absorption peak. Both the film thickness and the surface coverage of the CNTs increased linearly with the number of CNT/PDADMA bilayers deposited (film thickness up to 80 nm). Atomic force microscopy images showed a predominantly surface-parallel orientation of CNTs. Ohmic behavior with constant electrical conductivity of each CNT/PDADMA film and conductivity up to 4 · 103 S/m was found. A change in PDADMA molecular weight by almost a factor of ten has no effect on the film thickness and electrical conductivity, only the film/air roughness is reduced. However, increasing CNT concentration in the deposition dispersion from 0.15 up to 0.25 mg/ml results in an increased thickness of a CNT/PDADMA bilayer (by a factor of three). The increased bilayer thickness is accompanied by a decreased electrical conductivity (by a factor of four). The decreased conductivity is attributed to the increased monomer/CNT ratio.
- ItemProgress and challenges in using sustainable carbon anodes in rechargeable metal-ion batteries(Amsterdam [u.a.] : Elsevier, 2021) Soltani, Niloofar; Bahrami, Amin; Giebeler, Lars; Gemming, Thomas; Mikhailova, DariaRechargeable lithium-ion batteries (LIBs) are one of the most promising alternatives to effectively bypass fossil fuels. However, long-term energy application of LIBs could be restricted in the future due to the increased production cost of LIB arising from the shortage and inaccessibility of Li in the Earth's crust. Na or K have been considered as substitutes for Li but in spite of their natural abundance, they suffer from low gravimetric/volumetric energy density. An alternative to increase the efficiency of sodium-ion battery (SIBs) and potassium-ion battery (KIBs) is to focus on finding the high‐performing negative electrode, the anode. The large volume changes of alloying and conversion type anodes for KIBs and SIBs make hard carbons to a better option on this regard than usual graphitic carbons, but a key obstacle is the reliance on unsustainable sources. Thus, biomass-derived carbon could offer a promising alternative, and it has indeed been in the focus of much recent work. This review highlights the recent advances in using carbon extracted from various biomass sources in rechargeable Li-, Na-, and K-ion batteries. Maximizing the energy and power densities as well as the lifetime of carbon anodes require an exploration of the right balance between carbon structures, pore morphology, chemical composition and alkali metal-ion storage. Thus, in this review, first, we take stock of key challenges and opportunities to extract carbon from various plants structural components and identify the extracted carbon structure compared to graphite-like structure. Then, we provide an overview on morphological and structural modification of the extracted carbons. Finally, we show how the physicochemical properties, structural alignment and morphological variation of the biomass-derived carbon can affect the storage mechanism and electrochemical performance. The extensive overview of this topic provided here is expected to stimulate further work on environmentally friendly battery design and towards the optimization of the battery performance. Electrode materials in alkali-metal-ion batteries that are based on biomass-derived carbon may allow not only a technical breakthrough, but also an ethically and socially acceptable product.
- ItemTowards hybrid one-pot/one-electrode Pd-NPs-based nanoreactors for modular biocatalysis(Amsterdam [u.a.] : Elsevier, 2021) Koch, M.; Apushkinskaya, N.; Zolotukhina, E.V.; Silina, Y.E.Here, fundamental aspects affecting template-assisted engineering of oxidase-associated peroxide oxidation co-catalysis of the modeled microanalytical system based on the hybrid palladium nanoparticles (Pd-NPs) with tailored functional properties were studied. By an accurate tuning and validation of the experimental setup, a modular Pd-NPs-doped one-pot/one-electrode amperometric nanobiosensor for advanced multiplex analyte detection was constructed. The specific operational conditions (electrochemical read-out mode, pH, regeneration procedure) of the modular one-pot/one-electrode nanobiosensor allowed a reliable sensing of L-lactate (with linear dynamic range, LDR = 500 µM – 2 mM, R2 = 0.977), D-glucose (with LDR = 200 µM – 50 mM, R2 = 0.987), hydrogen peroxide (with LDR = 20 µM – 100 mM, R2 = 0.998) and glutaraldehyde (with LDR = 1 – 100 mM, R2 = 0.971). In addition, mechanistic aspects influencing the performance of Pd-NPs-doped one-pot/one-electrode for multiplex analyte sensing were studied in detail. The designed one-pot/one-electrode amperometric nanobiosensor showed a thin layer electrochemical behavior that greatly enhanced electron transfer between the functional hybrid layer and the electrode. Finally, a specific regeneration procedure of the hybrid one-pot/one-electrode and algorithm towards its usage for modular biocatalysis were developed. The reported strategy can readily be considered as a guideline towards the fabrication of commercialized nanobiosensors with tailored properties for advanced modular biocatalysis.
- ItemRhodium-catalyzed borylative carbon monoxide reduction to gem-diborylmethane(Amsterdam [u.a.] : Elsevier, 2021) Xua, Jian-Xing; Wu, Fu-Peng; Wu, Xiao-FengHerein, we developed a rhodium-catalyzed reduction of CO with bis(pinacolato)diboron (B2pin2) under atmospheric pressure of CO with silane as the hydride source, gem-diborylmethane [H2C(Bpin)2] as a versatile and fundamental C1 compound can be formed. Notably, this is the first example on transition metal-catalyzed borylation of CO. © 2020 The Author(s)
- ItemSelf-organized formation of unidirectional and quasi-one-dimensional metallic Tb silicide nanowires on Si(110)(Amsterdam [u.a.] : Elsevier, 2022) Appelfeller, Stephan; Franz, Martin; Karadag, Murat; Kubicki, Milan; Zielinski, Robert; Krivenkov, Maxim; Varykhalov, Andrei; Preobrajenski, Alexei; Dähne, MarioTerbium induced nanostructures on Si(110) and their growth are thoroughly characterized by low energy electron diffraction, scanning tunneling microscopy and spectroscopy, core-level and valence band photoelectron spectroscopy, and angle-resolved photoelectron spectroscopy. For low Tb coverage, a wetting layer forms with its surface fraction continuously decreasing with increasing Tb coverage in favor of the formation of unidirectional Tb silicide nanowires. These nanowires show high aspect ratios for high annealing temperatures or on substrates already containing Tb in the bulk. Both wetting layer and nanowires are stable for temperatures up to 750°C. In contrast to the nanowires, the wetting layer is characterized by a band gap. Thus, the metallic nanowires, which show a quasi-one-dimensional electronic band structure, are embedded in a semiconducting surrounding of wetting layer and substrate, insulating the nanowires from each other.