Filters

2012 - 201912020 - 20221

More filters

2020 - 20232
Reset filters

Settings

Subject: Nanoindentation × WGL Institute: IOM ×

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Nanoscale mechanical surface properties of single crystalline martensitic Ni-Mn-Ga ferromagnetic shape memory alloys
    (Bristol : IOP, 2012) Jakob, A.M.; Müller, M.; Rauschenbach, B.; Mayr, S.G.
    Located beyond the resolution limit of nanoindentation, contact resonance atomic force microscopy (CR-AFM) is employed for nano-mechanical surface characterization of single crystalline 14M modulated martensitic Ni-Mn-Ga (NMG) thin films grown by magnetron sputter deposition on (001) MgO substrates. Comparing experimental indentation moduli-obtained with CR-AFM-with theoretical predictions based on density functional theory (DFT) indicates the central role of pseudo plasticity and inter-martensitic phase transitions. Spatially highly resolved mechanical imaging enables the visualization of twin boundaries and allows for the assessment of their impact on mechanical behavior at the nanoscale. The CR-AFM technique is also briefly reviewed. Its advantages and drawbacks are carefully addressed.
  • Thumbnail Image
    Item
    Micro-embossing of micro-structures in RSA-501 as mold inserts for the replication of micro-lens arrays
    (Amsterdam : Elsevier, 2022) Kober, Julian; Rolón, Daniel; Hölzel, Florian; Kühne, Stefan; Oberschmidt, Dirk; Arnold, Thomas
    The production of mold inserts for the replication of micro-lens arrays through micro-embossing could be an alternative process route compared to diamond turning or milling in order to reduce time and costs. The rapidly solidified aluminum alloy RSA-501 is expected to form micro-structures with low surface roughness because of its ultra-fine grain structure. In micro-embossing challenges like elastic spring back effect, pile-ups, and forming accuracy depend on the material behavior. Therefore, RSA-501 was further characterized and the influence of polishing or flycutting on the material behavior was investigated. To further understand the grain and microstructure samples were sectioned along their cross and longitudinal directions. The grain structure of RSA-501 was oriented along the extrusion direction and the mean grain sizes were <1.00 μm. Furthermore, RSA-501 was micro-embossed to investigate the influence of the material behavior and surface preparation on the forming of micro-structures. The induced surface integrity through flycutting was not deep enough to influence the forming of micro-structures. Therefore, the workpiece surface can be prepared either by polishing or flycutting. When micro-embossing RSA-501, cross and longitudinal sections can be used. However, it is recommended to process the cross section because of its isotropic grain structure. It was shown that the curvature radius of micro-embossed concave structures differs from the tool radius. This is due to the elastic spring back effect. Since the embossed structure remains spherical, the spring back effect can be compensated by adjusting the tool radius.